Skip to content
worldfires
IT · Italy · –

Motta San Giovanni fire, June 2017 Motta San Giovanni

Out · last detection 20 Jun 2017, 12:49 UTC

The fire started on 19 June 2017 in Motta San Giovanni, Italy, and satellites saw it burning for 5 days. Copernicus mapped a burnt perimeter of 249 hectares from satellite imagery, spread across a single municipality.

It is the 30th largest in Reggio di Calabria since 2016 (of 101 with a page). Number 123 in Italy in 2017, of 361.

The power measured by the satellite is low (9.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
249ha
Copernicus perimeter
Duration
5days
19 Jun 2017 – 23 Jun 2017
Municipalities hit
1
municipalities
Started on
19 Jun
2017
Heat detections
8
in a single hotspot: 10 MW
Danger at start
25
High · FWI index
Average daily power
16MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 19 Jun23 Jun
20 Jun 2017

How it evolved, day by day

19 Jun 2017 · 4 MW · 3 20 Jun 2017 · 27 MW · 5
19 Jun 20 Jun

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
36km/h · peak gust
44%lowest humidity

It had gone 28 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Motta San Giovanni 5,574 inhabitants · 1.3 km from the centre where it started
    249 ha reached on 19 Jun
    5.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub34 %
  • Agricultural areas34 %
  • Other natural land32 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
19 Jun 25.2 °C 44 % 36 km/h 0.0 mm High 25
20 Jun 26.8 °C 44 % 28 km/h 0.0 mm Moderate 21
21 Jun 26.7 °C 48 % 34 km/h 0.0 mm High 29
22 Jun 27.4 °C 52 % 28 km/h 0.0 mm High 23
23 Jun 28.0 °C 50 % 28 km/h 0.0 mm High 25
24 Jun after 28.7 °C 39 % 34 km/h 0.0 mm High 30
25 Jun after 29.0 °C 43 % 27 km/h 0.0 mm High 27
26 Jun after 29.4 °C 39 % 32 km/h 0.0 mm High 29
27 Jun after 30.5 °C 42 % 28 km/h 0.0 mm High 31
28 Jun after 33.3 °C 30 % 32 km/h 0.0 mm High 35
29 Jun after 31.1 °C 45 % 27 km/h 0.0 mm High 29
30 Jun after 31.9 °C 36 % 42 km/h 0.0 mm Very high 49
1 Jul after 30.6 °C 46 % 39 km/h 0.0 mm High 32
2 Jul after 26.2 °C 51 % 56 km/h 0.0 mm Very high 48
3 Jul after 26.1 °C 50 % 46 km/h 0.0 mm Very high 38

Its twins: fires that started in the same weather

It started with an FWI of 24.9, a minimum humidity of 44% and 28 days without rain. Fires in the area that started in weather like this since 2016: 29.

FWI at the start 24.9
Minimum humidity 44 %
Days without rain 28
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Montebello Jonico fire, July 2020
184 ha 2 days FWI 25.4 Min. humidity 43 % 2 km away, in 2020

First rain (1 mm or more) after it ended: 3.3 mm on 4 Jul.

What happened to them

2 days
median duration
183 ha
median area
3 %
went past 1,000 ha
2.1 mm
rain at the end (median; 16 of 29 had it)

It burned an area similar to its twins (249 ha against a median of 183 ha) and lasted 5 days, against 2 days.

In 13 of 29, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.1 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
36km/h · max. gust

It was considered over on 23 Jun, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 16 of 29, with a median of 2.1 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 12 Jun 2017
After · 30 Jun 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 18 June 2017 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak15 µg/m³
Days over the guideline0 days
PM1020 µg/m³
17 Jun19 Jun21 Jun23 Jun
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy

Frequently asked questions

How long did the Motta San Giovanni fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 19 June 2017 to 23 June 2017 (5 days). The perimeter dates it from 20 June 2017 to 20 June 2017.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 249 hectares (2.5 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Motta San Giovanni (249 ha, 5.4 %).
Did the fire reach a town?
The fire started in Motta San Giovanni and came within 1.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 28.0 °C, humidity dropped to 44 % and gusts hit 36 km/h. The fire danger index (FWI) reached 29, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 29. Their median duration was 2 days and their median area 183 ha; 3 % went past 1,000 ha. In 13 of 29, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.1 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 20 June 2017 to 20 June 2017. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.