Skip to content
worldfires
TD · Chad · –

Monts de Lam fire, 4 January 2021 Monts de Lam

Out · last detection 20 Jan 2021, 11:38 UTC

The fire started on 4 January 2021 in Monts de Lam, Chad, and satellites saw it burning for 18 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,225 hectares from heat detections, spread across a single municipality.

It is the 32th largest in Logone Oriental since 2016 (of 41 with a page). Number 156 in Chad in 2021, of 197.

Burnt area
2,225ha
GWIS perimeter (Copernicus)
Duration
18days
4 Jan 2021 – 21 Jan 2021
Municipalities hit
1
departments
Started on
4 Jan
2021
Heat detections
73
in a single hotspot: 112 MW
Danger at start
51
Extreme · FWI index
Average daily power
60MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 4 Jan21 Jan
20 Jan 2021

How it evolved, day by day

4 Jan 2021 · 15 MW · 5 5 Jan 2021 · 90 MW · 11 6 Jan 2021 · 3 MW · 1 7 Jan 2021 · 40 MW · 10 8 Jan 2021 · 56 MW · 6 9 Jan 2021 · 67 MW · 4 10 Jan 2021 · 32 MW · 5 11 Jan 2021 · 32 MW · 4 12 Jan 2021 · 334 MW · 11 13 Jan 2021 · 32 MW · 2 14 Jan 2021 · 24 MW · 4 15 Jan 2021 · 150 MW · 4 16 Jan 2021 · 11 MW · 2 17 Jan 2021 · 14 MW · 3 20 Jan 2021 · 3 MW · 1
4 Jan 7 Jan 12 Jan 16 Jan

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
33km/h · peak gust
16%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1.4% of the area of London (22 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Monts de Lam where it started
    2,242 ha
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with 60 days without rain: 44 % of the area in Chad

Day High Min. humidity Peak gust Rain Danger (FWI)
4 Jan 35.1 °C 24 % 24 km/h 0.0 mm Extreme 51
5 Jan 35.8 °C 16 % 33 km/h 0.0 mm Extreme 61
6 Jan 35.8 °C 23 % 32 km/h 0.0 mm Extreme 59
7 Jan 35.5 °C 17 % 28 km/h 0.0 mm Extreme 56
8 Jan 35.4 °C 18 % 28 km/h 0.0 mm Extreme 56
9 Jan 34.4 °C 19 % 31 km/h 0.0 mm Extreme 60
10 Jan 35.1 °C 19 % 24 km/h 0.0 mm Extreme 50
11 Jan 34.8 °C 18 % 25 km/h 0.0 mm Extreme 51
12 Jan 35.3 °C 17 % 22 km/h 0.0 mm Very high 50
13 Jan 35.2 °C 17 % 32 km/h 0.0 mm Extreme 67
14 Jan 34.4 °C 17 % 30 km/h 0.0 mm Extreme 62
15 Jan 34.5 °C 18 % 29 km/h 0.0 mm Extreme 58
16 Jan 33.3 °C 20 % 24 km/h 0.0 mm Extreme 55
17 Jan 34.5 °C 22 % 27 km/h 0.0 mm Extreme 57
18 Jan 34.3 °C 18 % 23 km/h 0.0 mm Extreme 52
19 Jan 32.5 °C 19 % 25 km/h 0.0 mm Extreme 54
20 Jan 31.4 °C 20 % 27 km/h 0.0 mm Extreme 55
21 Jan 31.7 °C 17 % 27 km/h 0.0 mm Extreme 54
22 Jan after 31.2 °C 19 % 27 km/h 0.0 mm Extreme 53
23 Jan after 32.6 °C 18 % 23 km/h 0.0 mm Extreme 52
24 Jan after 34.2 °C 16 % 26 km/h 0.0 mm Extreme 56
25 Jan after 34.9 °C 17 % 25 km/h 0.0 mm Extreme 55
26 Jan after 35.3 °C 17 % 27 km/h 0.0 mm Extreme 57
27 Jan after 36.1 °C 15 % 31 km/h 0.0 mm Extreme 60
28 Jan after 35.9 °C 13 % 27 km/h 0.0 mm Extreme 56
29 Jan after 34.9 °C 16 % 25 km/h 0.0 mm Extreme 57
30 Jan after 35.1 °C 16 % 28 km/h 0.0 mm Extreme 52
31 Jan after 34.1 °C 17 % 25 km/h 0.0 mm Extreme 55

Its twins: fires that started in the same weather

It started with an FWI of 50.6, a minimum humidity of 24% and more than two months without rain. Fires in the area that started in weather like this since 2016: 32.

FWI at the start 50.6
Minimum humidity 24 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Rey-Bouba fire, January 2020
1,061 ha 3 days FWI 49.3 Min. humidity 25 % 173 km away, in 2020

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

9 days
median duration
1,988 ha
median area
100 %
went past 1,000 ha
—
rain at the end (median; 0 of 32 had it)

It burned an area similar to its twins (2,225 ha against a median of 1,988 ha) and lasted 18 days, against 9 days.

In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
33km/h · max. gust

It was considered over on 21 Jan, and not even 1 mm fell in the following ten days: it went out without rain. None of its 32 twins had rain when they ended.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 28 Dec 2020
After · 28 Jan 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 73Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Chad

Frequently asked questions

How long did the Monts de Lam fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 4 January 2021 to 21 January 2021 (18 days). The perimeter dates it from 4 January 2021 to 15 January 2021.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,225 hectares (22.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Monts de Lam (2,242 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 35.8 °C, humidity dropped to 16 % and gusts hit 33 km/h. The fire danger index (FWI) reached 67, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Chad (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 32. Their median duration was 9 days and their median area 1,988 ha; 100 % went past 1,000 ha. In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 15 January 2021 → 21 January 2021.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 4 January 2021 to 15 January 2021. 73 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.