Skip to content
worldfires
MX · Mexico · –

Mezquitic fire, 23 March 2021 Mezquitic, Villa Guerrero

Out · last detection 31 Mar 2021, 08:43 UTC

The fire started on 23 March 2021 in Mezquitic, Mexico, and satellites saw it burning for 9 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,958 hectares from heat detections, spread across 2 municipalities.

It is the 86th largest in Jalisco since 2016 (of 267 with a page). Number 118 in Mexico in 2021, of 294.

Burnt area
2,958ha
GWIS perimeter (Copernicus)
Duration
9days
23 Mar 2021 – 31 Mar 2021
Municipalities hit
2
municipalities
Started on
23 Mar
2021
Heat detections
230
in a single hotspot: 126 MW
Danger at start
50
Very high · FWI index
Average daily power
258MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 23 Mar31 Mar
31 Mar 2021

How it evolved, day by day

23 Mar 2021 · 173 MW · 16 24 Mar 2021 · 547 MW · 50 25 Mar 2021 · 1,227 MW · 95 26 Mar 2021 · 197 MW · 53 27 Mar 2021 · 1 MW · 1 28 Mar 2021 · 157 MW · 6 29 Mar 2021 · 4 MW · 2 30 Mar 2021 · 8 MW · 2 31 Mar 2021 · 8 MW · 5
23 Mar 25 Mar 27 Mar 29 Mar 31 Mar

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
61km/h · peak gust
7%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started. Rain came after the fire: 2.2 mm on 4 Apr.

This area had burned before

9% of the perimeter overlaps earlier fires recorded since 2016: 280 ha in 2017.

How big is it?

10 km
It burned the equivalent of 1.9% of the area of London (30 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Mezquitic where it started
    2,886 ha reached on 23 Mar
    0.8 %
  2. 83 ha reached on 26 Mar
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.55 ha
Residents≈ 70

Inside the perimeter there were about 0.55 hectares of built-up land and about 70 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

Official record

Several official records match this area

According to CONAFOR, 4 fires started inside this perimeter on these dates, totalling 1,809 ha (the satellite measured 2,958 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

CONAFOR records each fire that started at a different time or place separately; the satellite sees a single burned area, so this page groups them together. The numbers on the map show where each one started.

When each one burned

1 1,750 ha 2 27 ha 3 20 ha 4 12 ha
22 Mar30 Mar
negligence cause unknown or not published
  1. 1 Mezquitic Los Coconos 22 March 2021 1,750 ha · extinguished on 27 March 2021 · cause: negligence
  2. 2 Mezquitic Banco de Alisos 28 March 2021 27 ha · extinguished on 29 March 2021 · cause: unknown
  3. 3 Mezquitic La Cumbre 28 March 2021 20 ha · extinguished on 29 March 2021 · cause: unknown
  4. 4 Mezquitic Agua Zarca 30 March 2021 12 ha · extinguished on 31 March 2021 · cause: unknown

Total according to CONAFOR: 1,809 ha, 61 % of the 2,958 ha in the satellite perimeter.

CONAFOR (Comisión Nacional Forestal), estadística de incendios forestales en datos.gob.mx (CC BY 4.0). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Strong wind: 19 % of the area in Mexico 60 days without rain: 25 % of the area in Mexico

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Mar 19.8 °C 17 % 59 km/h 0.0 mm Very high 50
24 Mar 19.4 °C 17 % 61 km/h 0.0 mm Extreme 53
25 Mar 21.1 °C 12 % 48 km/h 0.0 mm Very high 42
26 Mar 22.6 °C 9 % 43 km/h 0.0 mm Very high 44
27 Mar 23.4 °C 7 % 40 km/h 0.0 mm Very high 45
28 Mar 25.2 °C 7 % 26 km/h 0.0 mm Very high 46
29 Mar 23.0 °C 13 % 34 km/h 0.0 mm High 32
30 Mar 23.5 °C 10 % 36 km/h 0.0 mm High 37
31 Mar 26.9 °C 7 % 25 km/h 0.0 mm Very high 44
1 Apr after 22.8 °C 20 % 42 km/h 0.0 mm Very high 43
2 Apr after 23.6 °C 15 % 24 km/h 0.0 mm High 32
3 Apr after 23.8 °C 21 % 37 km/h 0.9 mm High 29
4 Apr after 23.4 °C 25 % 34 km/h 2.2 mm Moderate 21

Its twins: fires that started in the same weather

It started with an FWI of 49.8, a minimum humidity of 17% and more than two months without rain. Fires in the area that started in weather like this since 2016: 34.

FWI at the start 49.8
Minimum humidity 17 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Del Nayar fire, May 2019
1,519 ha 15 days FWI 49.5 Min. humidity 17 % 86 km away, in 2019

First rain (1 mm or more) after it ended: 1.2 mm on 11 Jun.

What happened to them

10 days
median duration
2,464 ha
median area
100 %
went past 1,000 ha
1.6 mm
rain at the end (median; 16 of 34 had it)

It burned an area similar to its twins (2,958 ha against a median of 2,464 ha) and lasted 9 days, against 10 days.

In 18 of 34, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

2.2 mmfirst rain
4 Apr4 days after it ended
61km/h · max. gust

It was considered over on 31 Mar, and on 4 Apr 2.2 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 16 of 34, with a median of 1.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Mar 2021
After · 7 Apr 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 230Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Mezquitic fire last?
GWIS (Copernicus) dates it between 23 March 2021 and 31 March 2021: 9 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,958 hectares (29.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Mezquitic (2,886 ha, 0.8 %); Villa Guerrero (83 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 26.9 °C, humidity dropped to 7 % and gusts hit 61 km/h. The fire danger index (FWI) reached 53, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 34. Their median duration was 10 days and their median area 2,464 ha; 100 % went past 1,000 ha. In 18 of 34, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 230 Suomi-NPP VIIRS detections on those dates.
  • Compared with CONAFOR: 1,809 official ha against 2,958 ha of perimeter; similar, but with reservations.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.