Skip to content
worldfires
MY · Malaysia · →

Mersing fire, March 2021 Mersing

Out · last detection 12 Mar 2021, 18:14 UTC

The fire started on 6 March 2021 in Mersing, Malaysia, and satellites saw it burning for 7 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 548 hectares from heat detections, spread across a single municipality.

It is the 19th largest in Johor since 2016 (of 22 with a page). Number 13 in Malaysia in 2021, of 14.

The power measured by the satellite is low (15.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
548ha
GWIS perimeter (Copernicus)
Duration
7days
6 Mar 2021 – 12 Mar 2021
Municipalities hit
1
districts
Started on
6 Mar
2021
Heat detections
21
in a single hotspot: 15 MW
Danger at start
1
Very low · FWI index
Average daily power
11MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 6 Mar12 Mar
12 Mar 2021

How it evolved, day by day

6 Mar 2021 · 2 MW · 2 9 Mar 2021 · 40 MW · 6 10 Mar 2021 · 4 MW · 3 11 Mar 2021 · 9 MW · 6 12 Mar 2021 · 2 MW · 1
6 Mar 9 Mar 10 Mar 11 Mar 12 Mar

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
42km/h · peak gust
66%lowest humidity

It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 6.1 mm on 13 Mar.

This area had burned before

23% of the perimeter overlaps earlier fires recorded since 2016: 10 ha in 2016, 117 ha in 2019.

How big is it?

10 km
It burned the equivalent of 0.3% of the area of London (5.5 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Mersing where it started
    552 ha
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
6 Mar 29.2 °C 74 % 41 km/h 6.3 mm Very low 1
7 Mar 28.3 °C 73 % 28 km/h 7.7 mm Very low 0
8 Mar 29.3 °C 70 % 35 km/h 0.0 mm Very low 1
9 Mar 29.4 °C 67 % 41 km/h 0.6 mm Very low 4
10 Mar 29.5 °C 66 % 41 km/h 0.0 mm Low 6
11 Mar 28.8 °C 74 % 42 km/h 1.7 mm Very low 2
12 Mar 26.9 °C 84 % 30 km/h 28.3 mm Very low 0
13 Mar after 28.5 °C 77 % 32 km/h 6.1 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Feb 2021
After · 19 Mar 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 21Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Malaysia ›

Frequently asked questions

How long did the Mersing fire last?
GWIS (Copernicus) dates it between 6 March 2021 and 12 March 2021: 7 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 548 hectares (5.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Mersing (552 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 29.5 °C, humidity dropped to 66 % and gusts hit 42 km/h. The fire danger index (FWI) reached 6, class Low.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Malaysia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 999 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 999.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 21 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.