Skip to content
worldfires
RO · Romania · →

Mehadia fire, March 2026 Mehadia

Out · last detection 9 Mar 2026, 11:17 UTC

The fire started on 9 March 2026 in Mehadia, Romania, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 127 hectares from satellite imagery, spread across a single municipality.

It is the 155th largest in Caraș-Severin since 2016 (of 196 with a page). Number 48 in Romania in 2026, of 59.

The power measured by the satellite is low (4.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
127ha
Copernicus perimeter
Duration
≈ 1day
9 Mar 2026 – 9 Mar 2026
Municipalities hit
1
municipalities
Started on
9 Mar
2026
Heat detections
1
in a single hotspot: 4 MW
Danger at start
4
Very low · FWI index
Average daily power
4MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 9 Mar9 Mar

How it evolved, day by day

9 Mar 2026 · 4 MW · 1

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

12°high
59km/h · peak gust
46%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started.

This area had burned before

91% of the perimeter overlaps earlier fires recorded since 2016: 112 ha in 2022, 31 ha in 2024, 40 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 115 ha that had burned before.

What happened to each town

  1. Mehadia 3,512 inhabitants · 1.3 km from the centre where it started
    127 ha reached on 9 Mar
    0.6 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas67 %
  • Scrub and transitional woodland33 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
9 Mar 12.1 °C 46 % 59 km/h 0.0 mm Very low 4
10 Mar after 13.0 °C 35 % 48 km/h 0.0 mm Very low 4
11 Mar after 14.0 °C 30 % 35 km/h 0.0 mm Very low 5
12 Mar after 14.9 °C 43 % 21 km/h 0.0 mm Very low 4
13 Mar after 13.6 °C 45 % 35 km/h 0.0 mm Very low 5
14 Mar after 12.3 °C 46 % 45 km/h 0.0 mm Low 6
15 Mar after 11.1 °C 48 % 37 km/h 0.0 mm Very low 5
16 Mar after 11.0 °C 52 % 30 km/h 0.0 mm Very low 4
17 Mar after 11.1 °C 49 % 42 km/h 0.1 mm Very low 5
18 Mar after 9.9 °C 47 % 72 km/h 0.0 mm Low 8
19 Mar after 8.0 °C 60 % 39 km/h 0.9 mm Very low 2

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 2 Mar 2026
After · 16 Mar 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 7 March 2026 the air beside the fire reached 20 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak20 µg/m³
Days over the guideline0 days
PM1024 µg/m³
Optical depth0.18
789101112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Romania ›

Frequently asked questions

How long did the Mehadia fire last?
The official perimeter only gives the start date (9 March 2026). The end comes from the heat detections inside the perimeter: it burned until 9 March 2026 (1 day from 9 March 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 127 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Mehadia (127 ha, 0.6 %).
Did the fire reach a town?
The fire started in Mehadia and came within 1.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 12.1 °C, humidity dropped to 46 % and gusts hit 59 km/h. The fire danger index (FWI) reached 4, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Romania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. One Suomi-NPP VIIRS detection on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.