Skip to content
worldfires
EL · Greece · →

Megalopolis fire, September 2017 Μεγαλόπολης · Megalopolis, Tripoli

Out · last detection 11 Sept 2017, 11:52 UTC

The fire started on 11 September 2017 in Megalopolis, Greece, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 209 hectares from satellite imagery, spread across 2 municipalities.

It is the 28th largest in Peloponnese since 2016 (of 39 with a page). Number 16 in Greece in 2017, of 32.

The power measured by the satellite is low (11.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
209ha
Copernicus perimeter
Duration
1day
11 Sept 2017 – 11 Sept 2017
Municipalities hit
2
municipalities
Started on
11 Sept
2017
Heat detections
1
in a single hotspot: 11 MW
Danger at start
46
Very high · FWI index
Energy released
11MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 11 Sept11 Sept

How it evolved, day by day

11

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
64km/h · peak gust
15%lowest humidity

It had gone 11 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Megalopolis Μεγαλόπολης where it started
    196 ha reached on 11 Sept
    0.3 %
  2. Tripoli Δημοτική Ενότητα Τρίπολης 30,187 inhabitants · 23.7 km from the town
    14 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas79 %
  • Other natural land14 %
  • Sclerophyllous scrub6.1 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
11 Sept 33.7 °C 15 % 64 km/h 0.0 mm Very high 46
12 Sept after 27.3 °C 42 % 49 km/h 0.0 mm High 30
13 Sept after 30.3 °C 30 % 54 km/h 0.0 mm High 32
14 Sept after 31.0 °C 26 % 33 km/h 0.0 mm High 29
15 Sept after 31.9 °C 16 % 30 km/h 0.0 mm High 34
16 Sept after 32.1 °C 23 % 27 km/h 0.0 mm High 33
17 Sept after 34.6 °C 16 % 27 km/h 0.0 mm High 37
18 Sept after 35.3 °C 15 % 49 km/h 0.0 mm Very high 47
19 Sept after 33.9 °C 15 % 49 km/h 0.0 mm Very high 45
20 Sept after 28.2 °C 36 % 54 km/h 0.0 mm High 37
21 Sept after 22.5 °C 40 % 60 km/h 0.0 mm High 32

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 4 Sept 2017
After · 18 Sept 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 10 September 2017 the air beside the fire reached 24 µg/m³ of PM2.5. That day averaged 17: 1.2 times the WHO daily guideline (15).

PM2.5 peak24 µg/m³
Days over the guideline2 days
PM1069 µg/m³
91011121314
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Greece ›

Frequently asked questions

How long did the Megalopolis fire last?
Copernicus dates it between 11 September 2017 and 11 September 2017: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 209 hectares (2.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Megalopolis (196 ha, 0.3 %); Tripoli (14 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 23.7 km of Tripoli. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 33.7 °C, humidity dropped to 15 % and gusts hit 64 km/h. The fire danger index (FWI) reached 46, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Greece (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 199

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 199.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.