Skip to content
worldfires
IT · Italy · →

Mazzarrone fire, July 2021 Mazzarrone, Chiaramonte Gulfi

Out · last detection 13 Jul 2021, 12:24 UTC

The fire started on 13 July 2021 in Mazzarrone, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 123 hectares from satellite imagery, spread across 2 municipalities.

It is the 60th largest in Catania since 2016 (of 76 with a page). Number 234 in Italy in 2021, of 291.

The power measured by the satellite is low (3.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
123ha
Copernicus perimeter
Duration
1day
13 Jul 2021 – 13 Jul 2021
Municipalities hit
2
municipalities
Started on
13 Jul
2021
Heat detections
2
in a single hotspot: 4 MW
Danger at start
22
High · FWI index
Energy released
7MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 13 Jul13 Jul

How it evolved, day by day

13

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
25km/h · peak gust
57%lowest humidity

It had gone 30 days without rain (1 mm or more) when it started.

This area had burned before

12% of the perimeter overlaps earlier fires recorded since 2016: 15 ha in 2018.

What happened to each town

  1. Mazzarrone 3,965 inhabitants · 1.3 km from the town where it started
    123 ha reached on 13 Jul
    3.5 %
  2. Chiaramonte Gulfi 2,783 inhabitants · 16.4 km from the town
    0 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas63 %
  • Sclerophyllous scrub37 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Jul 27.9 °C 57 % 25 km/h 0.0 mm High 22
14 Jul after 27.9 °C 62 % 31 km/h 0.0 mm Moderate 21
15 Jul after 27.9 °C 54 % 35 km/h 0.0 mm High 22
16 Jul after 27.2 °C 44 % 50 km/h 0.0 mm High 32
17 Jul after 25.4 °C 65 % 50 km/h 0.0 mm High 26
18 Jul after 26.1 °C 58 % 45 km/h 0.0 mm High 25
19 Jul after 25.3 °C 62 % 26 km/h 0.0 mm Moderate 19
20 Jul after 25.7 °C 66 % 22 km/h 0.0 mm Moderate 17
21 Jul after 26.7 °C 58 % 26 km/h 0.0 mm Moderate 18
22 Jul after 27.8 °C 53 % 32 km/h 0.0 mm Moderate 21
23 Jul after 27.2 °C 56 % 24 km/h 0.0 mm Moderate 20

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Jul 2021
After · 20 Jul 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 July 2021 the air beside the fire reached 21 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak21 µg/m³
Days over the guideline0 days
PM1036 µg/m³
111213141516
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Mazzarrone fire last?
Copernicus dates it between 13 July 2021 and 13 July 2021: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 123 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Mazzarrone (123 ha, 3.5 %); Chiaramonte Gulfi (0 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 1.3 km of Mazzarrone. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 27.9 °C, humidity dropped to 57 % and gusts hit 25 km/h. The fire danger index (FWI) reached 22, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.