Skip to content
worldfires
UA · Ukraine · →

Marinka fire, 31 July 2026 Мар'їнський район · Marinka

Out · last detection 1 Aug 2026, 11:04 UTC

The fire started on 31 July 2026 in Marinka, Ukraine, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 335 hectares from satellite imagery, spread across a single municipality.

It is the 214th largest in Donetsk Oblast since 2016 (of 1004 with a page). Number 242 in Ukraine in 2026, of 984.

The power measured by the satellite is low (11.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
335ha
Copernicus perimeter
Duration
≈ 2days
31 Jul 2026 – 1 Aug 2026
Municipalities hit
1
districts
Started on
31 Jul
2026
Heat detections
8
in a single hotspot: 12 MW
Danger at start
16
Moderate · FWI index
Average daily power
27MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 31 Jul1 Aug
1 Aug 2026

How it evolved, day by day

31 Jul 2026 · 1 MW · 2 1 Aug 2026 · 53 MW · 6
31 Jul 1 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
37km/h · peak gust
35%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 11 Aug.

This area had burned before

61% of the perimeter overlaps earlier fires recorded since 2016: 87 ha in 2023, 158 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 203 ha that had burned before.

What happened to each town

  1. Marinka Мар'їнський район 90,434 inhabitants · 31.7 km from the centre where it started
    334 ha reached on 31 Jul
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas75 %
  • Other natural land19 %
  • Mixed forest3.6 %
  • Artificial surfaces2.4 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2025
Built-up area3.7 ha
Residents≈ 150

Inside the perimeter there were about 3.7 hectares of built-up land and about 150 residents (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 Jul 28.0 °C 35 % 37 km/h 0.0 mm Moderate 16
1 Aug 29.2 °C 36 % 26 km/h 0.0 mm Moderate 14
2 Aug after 31.0 °C 34 % 31 km/h 0.0 mm Moderate 18
3 Aug after 31.8 °C 30 % 37 km/h 0.0 mm High 22
4 Aug after 32.7 °C 27 % 33 km/h 0.0 mm High 23
5 Aug after 33.2 °C 27 % 28 km/h 0.0 mm High 23
6 Aug after 34.3 °C 26 % 30 km/h 0.0 mm High 25
7 Aug after 35.1 °C 24 % 39 km/h 0.0 mm High 31
8 Aug after 33.9 °C 26 % 36 km/h 0.0 mm High 30
9 Aug after 32.9 °C 34 % 40 km/h 0.2 mm High 32
10 Aug after 30.5 °C 39 % 37 km/h 0.0 mm High 29
11 Aug after 32.8 °C 36 % 31 km/h 1.3 mm Moderate 19

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Jul 2026
After · 8 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 August 2026 the air beside the fire reached 20 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak20 µg/m³
Days over the guideline0 days
PM1025 µg/m³
Optical depth0.30
293031123
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Marinka fire last?
The official perimeter only gives the start date (31 July 2026). The end comes from the heat detections inside the perimeter: it burned until 1 August 2026 (2 days from 31 July 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 335 hectares (3.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Marinka (334 ha, 0.2 %).
Did the fire reach a town?
The fire started in Marinka and came within 31.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.2 °C, humidity dropped to 35 % and gusts hit 37 km/h. The fire danger index (FWI) reached 16, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.