Skip to content
worldfires
AU · Australia · –

Maralinga Tjarutja fire, November 2020 Maralinga Tjarutja

Out · last detection 19 Nov 2020, 05:44 UTC

The fire started on 8 November 2020 in Maralinga Tjarutja, Australia, and satellites saw it burning for 12 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 6,449 hectares from heat detections, spread across a single municipality.

It is the 53th largest in South Australia since 2016 (of 69 with a page). Number 51 in Australia in 2020, of 67.

Compare with…
Burnt area
6,449ha
GWIS perimeter (Copernicus)
Duration
12days
8 Nov 2020 – 19 Nov 2020
Municipalities hit
1
local government areas
Started on
8 Nov
2020
Heat detections
290
in a single hotspot: 192 MW
Danger at start
98
Very extreme · FWI index
Average daily power
530MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 8 Nov19 Nov
19 Nov 2020

How it evolved, day by day

8 Nov 2020 · 156 MW · 37 9 Nov 2020 · 669 MW · 34 10 Nov 2020 · 2,381 MW · 107 11 Nov 2020 · 355 MW · 32 12 Nov 2020 · 22 MW · 7 13 Nov 2020 · 188 MW · 18 14 Nov 2020 · 1,408 MW · 47 15 Nov 2020 · 8 MW · 1 17 Nov 2020 · 104 MW · 5 19 Nov 2020 · 14 MW · 2
8 Nov 10 Nov 12 Nov 14 Nov 17 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

42°high
66km/h · peak gust
5%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 4.1% of the area of London (64 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Maralinga Tjarutja where it started
    6,447 ha
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 43 % of the area in Australia Strong wind: 39 % of the area in Australia Very dry air: 28 % of the area in Australia

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Nov 38.9 °C 6 % 63 km/h 0.1 mm Very extreme 98
9 Nov 41.3 °C 7 % 59 km/h 0.0 mm Very extreme 104
10 Nov 38.3 °C 7 % 66 km/h 0.0 mm Very extreme 102
11 Nov 29.0 °C 15 % 41 km/h 0.0 mm Extreme 68
12 Nov 29.7 °C 22 % 38 km/h 0.0 mm High 32
13 Nov 32.0 °C 16 % 38 km/h 0.0 mm High 37
14 Nov 42.3 °C 5 % 56 km/h 0.0 mm Very extreme 115
15 Nov 34.8 °C 16 % 59 km/h 0.0 mm Extreme 69
16 Nov 27.9 °C 15 % 51 km/h 0.0 mm Extreme 64
17 Nov 34.5 °C 10 % 41 km/h 0.0 mm Very extreme 71
18 Nov 40.2 °C 12 % 64 km/h 0.2 mm Very extreme 108
19 Nov 35.1 °C 24 % 39 km/h 0.0 mm Extreme 54
20 Nov after 35.7 °C 17 % 43 km/h 0.0 mm Extreme 65
21 Nov after 39.6 °C 13 % 52 km/h 0.0 mm Extreme 63
22 Nov after 31.4 °C 27 % 49 km/h 0.0 mm Extreme 64
23 Nov after 27.6 °C 25 % 43 km/h 0.0 mm Extreme 52
24 Nov after 31.8 °C 14 % 31 km/h 0.0 mm Very high 42
25 Nov after 39.6 °C 9 % 37 km/h 0.0 mm Extreme 68
26 Nov after 38.9 °C 13 % 40 km/h 0.0 mm Extreme 54
27 Nov after 43.6 °C 11 % 44 km/h 0.0 mm Very extreme 82
28 Nov after 36.2 °C 23 % 58 km/h 0.0 mm Extreme 68
29 Nov after 30.5 °C 20 % 47 km/h 0.0 mm Very high 49

Its twins: fires that started in the same weather

It started with an FWI of 98.2, a minimum humidity of 6% and 4 days without rain. Fires in the area that started in weather like this since 2017: 5.

FWI at the start 98.2
Minimum humidity 6 %
Days without rain 4
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Maralinga Tjarutja fire, December 2021
5,611 ha 5 days FWI 101.7 Min. humidity 13 % 26 km away, in 2021

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

Fires in the area that started in similar weather: 5. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
66km/h · max. gust

It was considered over on 19 Nov, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2017.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Nov 2020
After · 26 Nov 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 290Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Australia

Frequently asked questions

How long did the Maralinga Tjarutja fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 8 November 2020 to 19 November 2020 (12 days). The perimeter dates it from 8 November 2020 to 17 November 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 6,449 hectares (64.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Maralinga Tjarutja (6,447 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 42.3 °C, humidity dropped to 5 % and gusts hit 66 km/h. The fire danger index (FWI) reached 115, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Australia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 000 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 17 November 2020 → 19 November 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 000.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 8 November 2020 to 17 November 2020. 290 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.