Skip to content
worldfires
FR · France · →

Mana fire, 14 October 2026 Mana

Burning · last detection 23 Oct 2026, 17:02 UTC

Satellites first detected fire on 14 October 2026 in Mana, France. It has been active for 10 days, with 22 heat detections and an area with fire of about 224 hectares rebuilt from them, spread across a single municipality.

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

Satellites detected fire on 23 Oct 2026, 17:02 UTC. Everything suggests it is still burning. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Area with fire
≈ 224ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
14 Oct 2026 – 23 Oct 2026
Municipalities hit
1
communes
Started on
14 Oct
2026
Heat detections
22
in a single hotspot: 62 MW
Danger at start
10
Low · FWI index
Energy released
285MW
sum of detected power

Where it burned

23 Oct 2026
HOTSPOTS BY DAY 14 Oct23 Oct

How it evolved, day by day

14151617181920212223

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
33km/h · peak gust
34%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

What happened to each town

  1. Mana 10,957 inhabitants · 1.3 km from the town where it started
    224 ha reached on 14 Oct
    0.0 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Sept 34.5 °C 44 % 26 km/h 0.0 mm Low 10
24 Sept 35.5 °C 46 % 28 km/h 1.1 mm Low 11
25 Sept 36.3 °C 41 % 28 km/h 0.0 mm Moderate 16
26 Sept 35.8 °C 38 % 27 km/h 0.0 mm Moderate 18
27 Sept 36.5 °C 34 % 33 km/h 0.0 mm High 22
28 Sept 36.2 °C 39 % 26 km/h 0.1 mm High 21
29 Sept 34.1 °C 51 % 24 km/h 3.1 mm Very low 5
30 Sept 34.8 °C 44 % 28 km/h 0.0 mm Moderate 14
1 Oct 35.0 °C 39 % 28 km/h 0.0 mm Moderate 18
2 Oct 34.3 °C 46 % 31 km/h 0.0 mm Moderate 19

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Oct 2026
After · 23 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 22 September 2026 the air beside the fire reached 44 µg/m³ of PM2.5. That day averaged 22: 1.5 times the WHO daily guideline (15).

PM2.5 peak44 µg/m³
Days over the guideline1 day
PM1047 µg/m³
Optical depth0.52
212223242526272829301
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 22Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in France ›

Frequently asked questions

How long did the Mana fire last?
According to the heat detections seen by satellite, it burned from 14 October 2026 to 23 October 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 224 hectares with fire (2.2 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire only entered Mana (224 ha, 0.0 %).
Is the Mana fire still active?
Yes: satellites detected fire on 23 Oct 2026, 17:02 UTC. Check the emergency service for the official status.
Did the fire reach a town?
The closest fire to a town centre came within 1.3 km of Mana. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 36.5 °C, humidity dropped to 34 % and gusts hit 33 km/h. The fire danger index (FWI) reached 22, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of France (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 18

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 18.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM5 (Open Data Commons Attribution License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.