Skip to content
worldfires
MG · Madagascar · →

Mampikony fire, October 2026 Mampikony

Out · last detection 5 Oct 2026, 21:36 UTC

The fire started on 3 October 2026 in Mampikony, Madagascar, and satellites saw it burning for 4 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,696 hectares from heat detections, spread across a single municipality.

It is the 33th largest in Sofia since 2016 (of 163 with a page). Number 19 in Madagascar in 2026, of 91.

Burnt area
3,696ha
GWIS perimeter (Copernicus)
Duration
4days
3 Oct 2026 – 6 Oct 2026
Municipalities hit
1
districts
Started on
3 Oct
2026
Heat detections
144
in a single hotspot: 45 MW
Danger at start
48
Very high · FWI index
Energy released
1.2GW
sum of detected power

Where it burned

5 Oct 2026
HOTSPOTS BY DAY 3 Oct6 Oct

How it evolved, day by day

345

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
56km/h · peak gust
25%lowest humidity

It had gone 44 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 9 Oct.

This area had burned before

37% of the perimeter overlaps earlier fires recorded since 2016: 1,052 ha in 2018, 18 ha in 2019, 811 ha in 2022. Part of it burned more than once, so the yearly figures add up to more than the 1,383 ha that had burned before.

What happened to each town

  1. Mampikony where it started
    3,716 ha reached on 3 Oct
    0.8 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Oct 33.5 °C 25 % 50 km/h 0.0 mm Very high 48
4 Oct 33.9 °C 25 % 52 km/h 0.0 mm Extreme 50
5 Oct 34.3 °C 26 % 56 km/h 0.0 mm Extreme 53
6 Oct 34.3 °C 29 % 50 km/h 0.0 mm Very high 50
7 Oct after 33.8 °C 27 % 57 km/h 0.0 mm Extreme 55
8 Oct after 35.7 °C 26 % 36 km/h 0.0 mm Very high 42
9 Oct after 36.4 °C 28 % 29 km/h 1.3 mm High 33

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Sept 2026
After · 13 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 5 October 2026 the air beside the fire reached 28 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak28 µg/m³
Days over the guideline0 days
PM1028 µg/m³
Optical depth0.54
123456789
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 144Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Madagascar ›

Frequently asked questions

How long did the Mampikony fire last?
GWIS (Copernicus) dates it between 3 October 2026 and 6 October 2026: 4 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,696 hectares (37.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Mampikony (3,716 ha, 0.8 %).
Is the Mampikony fire still active?
No fire detections since 5 Oct 2026, 21:36 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 34.3 °C, humidity dropped to 25 % and gusts hit 56 km/h. The fire danger index (FWI) reached 53, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Madagascar (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.