Skip to content
worldfires
ES · Spain · →

Lubrín fire, August 2025 Lubrín

Out · last detection 30 Aug 2025, 14:14 UTC

The fire started on 29 August 2025 in Lubrín, Spain, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 915 hectares from satellite imagery, spread across a single municipality.

It is the 7th largest in Almeria since 2016 (of 16 with a page). Number 46 in Spain in 2025, of 158.

Burnt area
915ha
Copernicus perimeter
Duration
2days
29 Aug 2025 – 30 Aug 2025
Municipalities hit
1
municipalities
Started on
29 Aug
2025
Heat detections
111
in a single hotspot: 79 MW
Danger at start
61
Extreme · FWI index
Energy released
2.0GW
sum of detected power

Where it burned

30 Aug 2025
HOTSPOTS BY DAY 29 Aug30 Aug

How it evolved, day by day

2930

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
50km/h · peak gust
16%lowest humidity

It had gone 30 days without rain (1 mm or more) when it started. Rain came after the fire: 6.7 mm on 8 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Lubrín 1,434 inhabitants · 1.6 km from the town where it started
    916 ha reached on 29 Aug
    6.6 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub70 %
  • Other natural land28 %
  • Agricultural areas1.5 %

Natura 2000 protected area affected: 76 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
29 Aug 30.5 °C 16 % 50 km/h 0.0 mm Extreme 61
30 Aug 31.1 °C 20 % 37 km/h 0.0 mm Extreme 52
31 Aug after 32.7 °C 20 % 49 km/h 0.0 mm Extreme 60
1 Sept after 28.4 °C 20 % 45 km/h 0.0 mm Extreme 55
2 Sept after 28.1 °C 17 % 41 km/h 0.0 mm Extreme 54
3 Sept after 28.8 °C 21 % 34 km/h 0.0 mm Very high 45
4 Sept after 32.9 °C 12 % 34 km/h 0.0 mm Very high 49
5 Sept after 26.4 °C 32 % 44 km/h 0.0 mm Very high 44
6 Sept after 26.0 °C 52 % 30 km/h 0.0 mm High 27
7 Sept after 29.3 °C 51 % 26 km/h 0.0 mm High 23
8 Sept after 31.5 °C 37 % 35 km/h 6.7 mm Low 8

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Aug 2025
After · 6 Sept 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 31 August 2025 the air beside the fire reached 128 µg/m³ of PM2.5. That day averaged 42: 2.8 times the WHO daily guideline (15).

PM2.5 peak128 µg/m³
Days over the guideline2 days
PM10158 µg/m³
Optical depth0.45
272829303112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 111Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Lubrín fire last?
Copernicus dates it between 29 August 2025 and 30 August 2025: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 915 hectares (9.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Lubrín (916 ha, 6.6 %).
Did the fire reach a town?
The closest fire to a town centre came within 1.6 km of Lubrín. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 31.1 °C, humidity dropped to 16 % and gusts hit 50 km/h. The fire danger index (FWI) reached 61, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.