Los Guájares fire, March 2020
Los Guájares, Vélez de Benaudalla
Out · last detection 14 Mar 2020, 14:17 UTC
The fire started on 14 March 2020 in Los Guájares, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 139 hectares from satellite imagery, spread across 2 municipalities. According to EGIF (MITECO), it was detected on 14 March 2020 at 11:10 and declared extinguished on 16 March 2020.
It is the 10th largest in Granada since 2016 (of 12 with a page). Number 68 in Spain in 2020, of 89.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
13.1°C · 75% RH
High of 13.1 °C and minimum humidity of 75% on 14 March 2020; gusts of 20 km/h on 14 March 2020.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official EGIF (MITECO) record
Matches: 134 ha in the official record (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
Coniferous forest60 %
Sclerophyllous scrub24 %
Other natural land14 %
Agricultural areas1.4 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
Official record
According to EGIF (MITECO), this fire started on 14 March 2020 and burned 134 ha (the satellite measured 139 ha).
Vélez de BenaudallaLa Bernardilla14 March 2020 · 11:10134 ha· extinguished on 16 March 2020· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
14 Mar
13.1 °C
75 %
20 km/h
0.0 mm
Low 8
15 Mar after
12.1 °C
81 %
23 km/h
1.2 mm
Low 6
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
↔
Before · 7 Mar 2020
After · 21 Mar 2020
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 15 March 2020 the air beside the fire reached 254 µg/m³ of PM2.5. That day averaged 65: 4.3 times the WHO daily guideline (15).
PM2.5 peak254µg/m³
Days over the guideline3days
PM1067µg/m³
WHO 15
12 Mar14 Mar16 Mar
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Copernicus dates it between 14 March 2020 and 14 March 2020: 1 day between the first and last image with fire. According to EGIF (MITECO), it was detected on 14 March 2020 at 11:10 and declared extinguished on 16 March 2020.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 139 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Los Guájares (104 ha, 1.2 %); Vélez de Benaudalla (35 ha, 0.4 %).
Did the fire reach a town?
The fire came within 1.6 km of the centre of Vélez de Benaudalla, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 13.1 °C, humidity dropped to 75 % and gusts hit 20 km/h. The fire danger index (FWI) reached 8, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 7 Suomi-NPP VIIRS detections on those dates.
Compared with EGIF (MITECO): 134 official ha against 139 ha of perimeter; they agree within 25%.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.