Skip to content
worldfires
ET · Ethiopia · –

Loma Bosa fire, December 2020 Loma Bosa, Denibu Gofa, Melekoza

Out · last detection

The fire started on in Loma Bosa, Ethiopia, and satellites saw it burning for 15 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,612 hectares from heat detections, spread across 3 municipalities.

It is number 42 by size of the 161 fires with a page that started in SNNPR since 2016. Number 58 in Ethiopia in 2020, of 177.

The power measured by the satellite is low (27.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
3,612ha
GWIS perimeter (Copernicus)
Duration
15days
10 Dec 2020 – 24 Dec 2020
Municipalities hit
3
districts
Started on
10 Dec
2020
Heat detections
136
in a single hotspot: 27 MW
Danger at start
20
Moderate · FWI index
Average daily power
65MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Dec24 Dec
24 Dec 2020

How it evolved, day by day

10 Dec 2020 · 38 MW · 10 11 Dec 2020 · 5 MW · 1 12 Dec 2020 · 38 MW · 13 13 Dec 2020 · 136 MW · 20 14 Dec 2020 · 63 MW · 17 15 Dec 2020 · 131 MW · 33 16 Dec 2020 · 117 MW · 19 17 Dec 2020 · 161 MW · 17 18 Dec 2020 · 22 MW · 3 20 Dec 2020 · 8 MW · 1 24 Dec 2020 · 1 MW · 2
10 Dec 13 Dec 17 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
24km/h · peak gust
22%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started.

This area had burned before

78% of the perimeter overlaps earlier fires recorded since 2016: 2,513 ha in 2016, 8 ha in 2018, 2,480 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 2,831 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2.3% of the area of London (36 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Loma Bosa where it started
    2,822 ha reached on 12 Dec
    2.4 %
  2. 580 ha reached on 14 Dec
    0.7 %
  3. 232 ha reached on 10 Dec
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Dec 31.1 °C 29 % 20 km/h 0.0 mm Moderate 20
11 Dec 31.8 °C 24 % 19 km/h 0.0 mm Moderate 20
12 Dec 30.0 °C 24 % 18 km/h 0.0 mm Moderate 20
13 Dec 31.6 °C 24 % 24 km/h 0.0 mm High 24
14 Dec 31.4 °C 28 % 18 km/h 0.0 mm High 24
15 Dec 32.3 °C 27 % 17 km/h 0.0 mm High 23
16 Dec 32.3 °C 22 % 17 km/h 0.0 mm High 24
17 Dec 32.4 °C 22 % 16 km/h 0.0 mm High 23
18 Dec 31.8 °C 26 % 18 km/h 0.0 mm High 26
19 Dec 31.9 °C 30 % 18 km/h 0.0 mm High 24
20 Dec 31.7 °C 31 % 17 km/h 0.0 mm High 25
21 Dec 29.9 °C 43 % 20 km/h 0.0 mm High 24
22 Dec 31.8 °C 37 % 22 km/h 0.0 mm High 23
23 Dec 30.6 °C 43 % 22 km/h 0.4 mm Moderate 21
24 Dec 32.0 °C 31 % 21 km/h 0.0 mm High 22
25 Dec after 32.7 °C 29 % 18 km/h 0.0 mm High 25
26 Dec after 32.7 °C 26 % 20 km/h 0.0 mm High 29
27 Dec after 31.7 °C 24 % 28 km/h 0.0 mm High 33
28 Dec after 32.8 °C 17 % 17 km/h 0.0 mm High 32
29 Dec after 32.7 °C 26 % 16 km/h 0.0 mm High 31
30 Dec after 32.7 °C 30 % 19 km/h 0.0 mm High 31
31 Dec after 30.5 °C 38 % 22 km/h 0.1 mm High 27
1 Jan after 29.6 °C 45 % 19 km/h 0.2 mm High 22
2 Jan after 29.6 °C 38 % 21 km/h 0.0 mm High 22
3 Jan after 29.5 °C 33 % 20 km/h 0.0 mm High 22

Its twins: fires that started in the same weather

It started with an FWI of 19.5, a minimum humidity of 29% and 4 days without rain. Fires in the area that started in weather like this since 2016: 17.

FWI at the start 19.5
Minimum humidity 29 %
Days without rain 4
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Gurafereda fire, January 2019
2,075 ha 8 days FWI 19.5 Min. humidity 31 % 190 km away, in 2019

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

14 days
median duration
2,655 ha
median area
100 %
went past 1,000 ha
2.0 mm
rain at the end (median; 4 of 17 had it)

It burned an area similar to its twins (3,612 ha against a median of 2,655 ha) and lasted 15 days, against 14 days.

In 13 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
24km/h · max. gust

It was considered over on 24 Dec, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 4 of 17, with a median of 2.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Dec 2020
After · 31 Dec 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 136Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ethiopia

Frequently asked questions

How long did the Loma Bosa fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 10 December 2020 to 24 December 2020 (15 days). The perimeter dates it from 12 December 2020 to 17 December 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,612 hectares (36.1 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Loma Bosa (2,822 ha, 2.4 %); Denibu Gofa (580 ha, 0.7 %); Melekoza (232 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 32.4 °C, humidity dropped to 22 % and gusts hit 24 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ethiopia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 14 days and their median area 2,655 ha; 100 % went past 1,000 ha. In 13 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 17 December 2020 → 24 December 2020.
  2. Start date: 12 December 2020 → 10 December 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 12 December 2020 to 17 December 2020. 136 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.