Skip to content
worldfires
TH · Thailand · –

Lom Sak fire, 12 February 2020 หล่มสัก · Nam Nao, Lom Kao, Lom Sak

Out · last detection 18 Feb 2020, 19:25 UTC

The fire started on 12 February 2020 in Lom Sak, Thailand, and satellites saw it burning for 9 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,544 hectares from heat detections, spread across 3 municipalities.

It is the 39th largest in Phetchabun Province since 2016 (of 84 with a page). Number 229 in Thailand in 2020, of 457.

The power measured by the satellite is low (10.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,544ha
GWIS perimeter (Copernicus)
Duration
9days
12 Feb 2020 – 20 Feb 2020
Municipalities hit
3
districts
Started on
12 Feb
2020
Heat detections
40
in a single hotspot: 11 MW
Danger at start
32
High · FWI index
Average daily power
20MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 12 Feb20 Feb
18 Feb 2020

How it evolved, day by day

12 Feb 2020 · 5 MW · 1 13 Feb 2020 · 40 MW · 6 14 Feb 2020 · 25 MW · 11 15 Feb 2020 · 47 MW · 14 16 Feb 2020 · 5 MW · 2 17 Feb 2020 · 8 MW · 2 18 Feb 2020 · 10 MW · 4
12 Feb 15 Feb 18 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

35°high
50km/h · peak gust
27%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

93% of the perimeter overlaps earlier fires recorded since 2016: 847 ha in 2016, 885 ha in 2017, 420 ha in 2018, 474 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 1,433 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1% of the area of London (15 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Nam Nao น้ำหนาว
    862 ha reached on 14 Feb
    0.9 %
  2. Lom Kao หล่มเก่า
    416 ha reached on 13 Feb
    0.4 %
  3. Lom Sak หล่มสัก where it started
    275 ha reached on 12 Feb
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area1.2 ha
Residents≈ 80

Inside the perimeter there were about 1.2 hectares of built-up land and about 80 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with 60 days without rain: 15 % of the area in Thailand

Day High Min. humidity Peak gust Rain Danger (FWI)
12 Feb 32.4 °C 46 % 35 km/h 0.0 mm High 32
13 Feb 32.9 °C 40 % 42 km/h 0.0 mm High 34
14 Feb 31.8 °C 43 % 50 km/h 0.0 mm Very high 41
15 Feb 33.4 °C 30 % 35 km/h 0.0 mm High 35
16 Feb 35.0 °C 27 % 19 km/h 0.0 mm High 30
17 Feb 29.8 °C 47 % 37 km/h 0.0 mm High 34
18 Feb 27.8 °C 47 % 37 km/h 0.0 mm High 33
19 Feb 29.8 °C 45 % 28 km/h 0.0 mm High 30
20 Feb 30.4 °C 43 % 34 km/h 0.0 mm High 31
21 Feb after 29.8 °C 42 % 45 km/h 0.0 mm High 36
22 Feb after 29.7 °C 41 % 46 km/h 0.0 mm Very high 39
23 Feb after 30.2 °C 41 % 34 km/h 0.0 mm High 32
24 Feb after 30.9 °C 39 % 25 km/h 0.0 mm High 29
25 Feb after 33.0 °C 33 % 19 km/h 0.0 mm High 29
26 Feb after 32.8 °C 34 % 24 km/h 0.0 mm High 31
27 Feb after 31.1 °C 42 % 27 km/h 0.0 mm High 33
28 Feb after 32.2 °C 36 % 22 km/h 0.0 mm High 30
29 Feb after 33.6 °C 38 % 20 km/h 0.0 mm High 29
1 Mar after 33.0 °C 47 % 22 km/h 0.2 mm High 29

Its twins: fires that started in the same weather

It started with an FWI of 31.7, a minimum humidity of 46% and more than two months without rain. Fires in the area that started in weather like this since 2016: 35.

FWI at the start 31.7
Minimum humidity 46 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Phu Luang fire, April 2023
2,047 ha 7 days FWI 31.1 Min. humidity 45 % 25 km away, in 2023

First rain (1 mm or more) after it ended: 2.1 mm on 9 Apr.

What happened to them

7 days
median duration
1,225 ha
median area
97 %
went past 1,000 ha
4.8 mm
rain at the end (median; 20 of 35 had it)

It burned an area similar to its twins (1,544 ha against a median of 1,225 ha) and lasted 9 days, against 7 days.

In 15 of 35, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
50km/h · max. gust

It was considered over on 20 Feb, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 20 of 35, with a median of 4.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 5 Feb 2020
After · 27 Feb 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 40Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Thailand

Frequently asked questions

How long did the Lom Sak fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 12 February 2020 to 20 February 2020 (9 days). The perimeter dates it from 12 February 2020 to 17 February 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,544 hectares (15.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Nam Nao (862 ha, 0.9 %); Lom Kao (416 ha, 0.4 %); Lom Sak (275 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 35.0 °C, humidity dropped to 27 % and gusts hit 50 km/h. The fire danger index (FWI) reached 41, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Thailand (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 35. Their median duration was 7 days and their median area 1,225 ha; 97 % went past 1,000 ha. In 15 of 35, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 199 · 191 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 17 February 2020 → 20 February 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 199 · 191.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 12 February 2020 to 17 February 2020. 40 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.