Skip to content
worldfires
UA · Ukraine · →

Lenine fire, 8 September 2025 Ленінський район · Lenine

Out · last detection 8 Sept 2025, 09:45 UTC

The fire started on 8 September 2025 in Lenine, Ukraine, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 262 hectares from satellite imagery, spread across a single municipality.

It is the 33th largest in Autonomous Republic of Crimea since 2016 (of 100 with a page). Number 469 in Ukraine in 2025, of 1359.

The power measured by the satellite is low (17.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
262ha
Copernicus perimeter
Duration
3days
8 Sept 2025 – 10 Sept 2025
Municipalities hit
1
districts
Started on
8 Sept
2025
Heat detections
10
in a single hotspot: 17 MW
Danger at start
26
High · FWI index
Energy released
68MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 8 Sept10 Sept

How it evolved, day by day

8

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

25°high
48km/h · peak gust
58%lowest humidity

It had gone 35 days without rain (1 mm or more) when it started. Rain came after the fire: 21.9 mm on 18 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Lenine Ленінський район 60,327 inhabitants · 57.4 km from the town where it started
    262 ha reached on 8 Sept
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land93 %
  • Mixed forest5.7 %
  • Artificial surfaces1.1 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Sept 24.8 °C 58 % 48 km/h 0.0 mm High 26
9 Sept 22.5 °C 64 % 46 km/h 5.0 mm Low 7
10 Sept 21.4 °C 83 % 45 km/h 10.9 mm Very low 0
11 Sept after 22.7 °C 57 % 53 km/h 0.2 mm Low 7
12 Sept after 22.7 °C 46 % 51 km/h 0.0 mm Moderate 15
13 Sept after 20.4 °C 49 % 60 km/h 0.0 mm High 22
14 Sept after 22.8 °C 52 % 65 km/h 0.0 mm High 25
15 Sept after 23.5 °C 45 % 56 km/h 0.0 mm High 25
16 Sept after 21.7 °C 53 % 36 km/h 0.0 mm Moderate 18
17 Sept after 22.8 °C 62 % 22 km/h 0.0 mm Moderate 12
18 Sept after 19.5 °C 76 % 44 km/h 21.9 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Sept 2025
After · 17 Sept 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 7 September 2025 the air beside the fire reached 10 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak10 µg/m³
Days over the guideline0 days
PM1015 µg/m³
Optical depth0.37
678910111213
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 10Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Lenine fire last?
Copernicus dates it between 8 September 2025 and 10 September 2025: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 262 hectares (2.6 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Lenine (262 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 57.4 km of Lenine. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 24.8 °C, humidity dropped to 58 % and gusts hit 48 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.