Skip to content
worldfires
FR · France · →

Larrau fire, March 2019 Larrau

Out · last detection 21 Mar 2019, 13:09 UTC

The fire started on 21 March 2019 in Larrau, France, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 119 hectares from satellite imagery, spread across a single municipality.

This record is most likely a pastoral burn (écobuage) in the Pyrenees, not a forest fire. In winter, grassland and scrub are burnt to renew the pasture, and this fire does not appear in France's official forest fire database (BDIFF). That is why it is left out of the fire rankings.

The power measured by the satellite is low (8.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
119ha
Copernicus perimeter
Duration
1day
21 Mar 2019 – 21 Mar 2019
Municipalities hit
1
communes
Started on
21 Mar
2019
Heat detections
3
in a single hotspot: 9 MW
Danger at start
0
Very low · FWI index
Average daily power
22MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 21 Mar21 Mar

How it evolved, day by day

21 Mar 2019 · 22 MW · 3

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

12°high
27km/h · peak gust
43%lowest humidity

It had gone one day without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Larrau 179 inhabitants · 3.7 km from the centre where it started
    119 ha reached on 21 Mar
    0.9 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land86 %
  • Broadleaved forest14 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Mar 12.0 °C 43 % 27 km/h 0.0 mm Very low 0
22 Mar after 15.7 °C 37 % 23 km/h 0.0 mm Very low 1
23 Mar after 16.9 °C 40 % 30 km/h 0.0 mm Very low 2
24 Mar after 15.9 °C 39 % 41 km/h 0.0 mm Very low 3
25 Mar after 9.7 °C 62 % 52 km/h 0.0 mm Very low 3
26 Mar after 10.9 °C 39 % 55 km/h 0.0 mm Very low 4
27 Mar after 11.3 °C 42 % 49 km/h 0.0 mm Very low 3
28 Mar after 12.8 °C 50 % 37 km/h 0.0 mm Very low 3
29 Mar after 15.8 °C 35 % 50 km/h 0.0 mm Very low 5
30 Mar after 15.8 °C 34 % 40 km/h 0.0 mm Very low 5
31 Mar after 14.4 °C 42 % 23 km/h 0.0 mm Very low 4

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 14 Mar 2019
After · 28 Mar 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 24 March 2019 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak15 µg/m³
Days over the guideline0 days
PM1020 µg/m³
192021222324
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in France ›

Frequently asked questions

How long did the Larrau fire last?
Copernicus dates it between 21 March 2019 and 21 March 2019: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 119 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Larrau (119 ha, 0.9 %).
Did the fire reach a town?
The fire started in Larrau and came within 3.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 12.0 °C, humidity dropped to 43 % and gusts hit 27 km/h. The fire danger index (FWI) reached 0, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of France (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 18 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 18.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 3 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Probably a vegetation burn: not counted in the totals.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM5 (Open Data Commons Attribution License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.