Skip to content
worldfires
NG · Nigeria · →

Kogi fire, February 2026 Kogi

Out · last detection 8 Mar 2026, 13:06 UTC

The fire started on 26 February 2026 in Kogi, Nigeria, and satellites saw it burning for 10 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,951 hectares from heat detections, spread across a single municipality.

It is the 18th largest in Kogi since 2016 (of 48 with a page). Number 126 in Nigeria in 2026, of 262.

Burnt area
2,951ha
GWIS perimeter (Copernicus)
Duration
10days
26 Feb 2026 – 7 Mar 2026
Municipalities hit
1
local government areas
Started on
26 Feb
2026
Heat detections
71
in a single hotspot: 128 MW
Danger at start
44
Very high · FWI index
Energy released
931MW
sum of detected power

Where it burned

8 Mar 2026
HOTSPOTS BY DAY 26 Feb7 Mar

How it evolved, day by day

262712345678

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

41°high
32km/h · peak gust
13%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

1% of the perimeter overlaps earlier fires recorded since 2016: 19 ha in 2020.

What happened to each town

  1. Kogi where it started
    2,968 ha reached on 25 Feb
    2.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
26 Feb 38.8 °C 14 % 28 km/h 0.0 mm Very high 44
27 Feb 38.0 °C 23 % 27 km/h 0.0 mm Very high 48
28 Feb 38.7 °C 22 % 24 km/h 0.0 mm Very high 43
1 Mar 38.7 °C 13 % 32 km/h 0.0 mm Very high 50
2 Mar 38.0 °C 24 % 26 km/h 0.0 mm Very high 44
3 Mar 39.0 °C 16 % 24 km/h 0.0 mm Very high 45
4 Mar 39.3 °C 24 % 28 km/h 0.0 mm Very high 46
5 Mar 38.7 °C 26 % 27 km/h 0.0 mm Very high 44
6 Mar 39.1 °C 30 % 30 km/h 0.0 mm Very high 42
7 Mar 41.0 °C 20 % 28 km/h 0.0 mm Very high 44
8 Mar after 41.4 °C 16 % 25 km/h 0.0 mm Very high 47
9 Mar after 42.2 °C 18 % 32 km/h 0.0 mm Extreme 51
10 Mar after 41.0 °C 26 % 41 km/h 0.0 mm Extreme 54
11 Mar after 38.8 °C 36 % 36 km/h 0.0 mm Very high 42
12 Mar after 40.2 °C 28 % 35 km/h 0.0 mm Very high 43
13 Mar after 40.8 °C 28 % 46 km/h 0.3 mm Very high 43
14 Mar after 41.3 °C 18 % 42 km/h 0.0 mm Extreme 55
15 Mar after 40.2 °C 27 % 35 km/h 0.0 mm Very high 49
16 Mar after 39.7 °C 20 % 43 km/h 0.0 mm Extreme 53
17 Mar after 40.6 °C 19 % 38 km/h 0.0 mm Extreme 54

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 19 Feb 2026
After · 14 Mar 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 February 2026 the air beside the fire reached 134 µg/m³ of PM2.5. That day averaged 103: 6.8 times the WHO daily guideline (15).

PM2.5 peak134 µg/m³
Days over the guideline15 days
PM10434 µg/m³
Optical depth1.07
242526272812345678910
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 71Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Nigeria ›

Frequently asked questions

How long did the Kogi fire last?
GWIS (Copernicus) dates it between 26 February 2026 and 7 March 2026: 10 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,951 hectares (29.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Kogi (2,968 ha, 2.0 %).
What was the weather like?
During the fire the temperature reached 41.0 °C, humidity dropped to 13 % and gusts hit 32 km/h. The fire danger index (FWI) reached 50, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Nigeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.