Skip to content
worldfires
TR · Türkiye · →

Kocaköy fire, July 2016 Kocaköy, Lice

Out · last detection 2 Jul 2016, 09:47 UTC

The fire started on 2 July 2016 in Kocaköy, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 313 hectares from satellite imagery, spread across 2 municipalities.

It is the 44th largest in Diyarbakır since 2016 (of 110 with a page). Number 106 in Türkiye in 2016, of 223.

The power measured by the satellite is low (7.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
313ha
Copernicus perimeter
Duration
1day
2 Jul 2016 – 2 Jul 2016
Municipalities hit
2
districts
Started on
2 Jul
2016
Heat detections
3
in a single hotspot: 7 MW
Danger at start
49
Very high · FWI index
Energy released
20MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 2 Jul2 Jul

How it evolved, day by day

2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
34km/h · peak gust
18%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Kocaköy 16,679 inhabitants · 3.9 km from the town where it started
    307 ha reached on 2 Jul
    1.1 %
  2. Lice 26,163 inhabitants · 16.6 km from the town
    8 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land47 %
  • Scrub and transitional woodland39 %
  • Agricultural areas14 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
2 Jul 37.0 °C 18 % 34 km/h 0.0 mm Very high 49
3 Jul after 37.5 °C 18 % 32 km/h 0.0 mm Extreme 51
4 Jul after 37.9 °C 16 % 30 km/h 0.0 mm Very high 48
5 Jul after 36.9 °C 16 % 37 km/h 0.0 mm Extreme 53
6 Jul after 35.5 °C 18 % 48 km/h 0.0 mm Extreme 55
7 Jul after 36.5 °C 18 % 22 km/h 0.0 mm Very high 43
8 Jul after 35.3 °C 21 % 42 km/h 0.0 mm Extreme 53
9 Jul after 35.6 °C 17 % 31 km/h 0.0 mm Very high 47
10 Jul after 35.9 °C 11 % 35 km/h 0.0 mm Extreme 52
11 Jul after 33.6 °C 14 % 53 km/h 0.0 mm Extreme 61
12 Jul after 34.9 °C 12 % 45 km/h 0.0 mm Extreme 58

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Jun 2016
After · 9 Jul 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 30 June 2016 the air beside the fire reached 19 µg/m³ of PM2.5. That day averaged 15: 1.0 times the WHO daily guideline (15).

PM2.5 peak19 µg/m³
Days over the guideline0 days
PM1022 µg/m³
3012345
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Kocaköy fire last?
Copernicus dates it between 2 July 2016 and 2 July 2016: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 313 hectares (3.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Kocaköy (307 ha, 1.1 %); Lice (8 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 3.9 km of Kocaköy. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 37.0 °C, humidity dropped to 18 % and gusts hit 34 km/h. The fire danger index (FWI) reached 49, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.