Skip to content
worldfires
RU · Russia · –

Khankaysky District fire, 16 February 2019 Khankaysky District, Пограничный район

Out · last detection 28 Feb 2019, 04:36 UTC

The fire started on 16 February 2019 in Khankaysky District, Russia, and satellites saw it burning for 13 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,479 hectares from heat detections, spread across 2 municipalities.

It is the 72th largest in Primorsky Krai since 2016 (of 121 with a page). Number 386 in Russia in 2019, of 610.

Burnt area
4,479ha
GWIS perimeter (Copernicus)
Duration
13days
16 Feb 2019 – 28 Feb 2019
Municipalities hit
2
districts
Started on
16 Feb
2019
Heat detections
172
in a single hotspot: 146 MW
Danger at start
7
Low · FWI index
Average daily power
139MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 16 Feb28 Feb
28 Feb 2019

How it evolved, day by day

16 Feb 2019 · 21 MW · 4 17 Feb 2019 · 37 MW · 5 21 Feb 2019 · 20 MW · 5 22 Feb 2019 · 203 MW · 50 23 Feb 2019 · 503 MW · 33 24 Feb 2019 · 206 MW · 30 25 Feb 2019 · 92 MW · 18 26 Feb 2019 · 56 MW · 10 27 Feb 2019 · 247 MW · 16 28 Feb 2019 · 6 MW · 1
16 Feb 21 Feb 23 Feb 25 Feb 27 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

8°high
57km/h · peak gust
10%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

34% of the perimeter overlaps earlier fires recorded since 2016: 92 ha in 2016, 41 ha in 2017, 1,413 ha in 2018.

How big is it?

10 km
It burned the equivalent of 2.8% of the area of London (45 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Khankaysky District where it started
    3,744 ha reached on 16 Feb
    1.4 %
  2. 729 ha reached on 21 Feb
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Strong wind: 9.7 % of the area in Russia 60 days without rain: < 1 % of the area in Russia

Day High Min. humidity Peak gust Rain Danger (FWI)
16 Feb -1.8 °C 25 % 50 km/h 0.0 mm Low 7
17 Feb 1.9 °C 23 % 57 km/h 0.0 mm Low 9
18 Feb 7.3 °C 16 % 43 km/h 0.0 mm Low 7
19 Feb 5.3 °C 16 % 18 km/h 0.0 mm Very low 4
20 Feb 2.9 °C 32 % 37 km/h 0.0 mm Low 6
21 Feb 6.3 °C 19 % 40 km/h 0.0 mm Low 8
22 Feb 5.9 °C 21 % 47 km/h 0.0 mm Low 7
23 Feb 5.1 °C 21 % 38 km/h 0.0 mm Low 8
24 Feb 6.1 °C 22 % 51 km/h 0.0 mm Low 11
25 Feb 2.5 °C 16 % 53 km/h 0.0 mm Low 10
26 Feb 1.7 °C 19 % 50 km/h 0.0 mm Low 11
27 Feb 5.5 °C 10 % 30 km/h 0.0 mm Low 8
28 Feb 7.7 °C 25 % 30 km/h 0.0 mm Low 7
1 Mar after 5.9 °C 20 % 59 km/h 0.2 mm Low 10
2 Mar after 9.1 °C 14 % 29 km/h 0.0 mm Low 8
3 Mar after 9.5 °C 23 % 42 km/h 0.0 mm Moderate 12
4 Mar after 7.8 °C 24 % 25 km/h 0.0 mm Low 9
5 Mar after 9.3 °C 27 % 23 km/h 0.0 mm Low 7
6 Mar after 3.8 °C 19 % 42 km/h 0.0 mm Low 10
7 Mar after 5.0 °C 19 % 44 km/h 0.0 mm Moderate 12
8 Mar after 10.7 °C 11 % 36 km/h 0.0 mm Moderate 14
9 Mar after 8.7 °C 24 % 65 km/h 0.0 mm Moderate 21
10 Mar after 7.4 °C 16 % 25 km/h 0.0 mm Low 10

Its twins: fires that started in the same weather

It started with an FWI of 7.3, a minimum humidity of 25% and more than two months without rain. Fires in the area that started in weather like this since 2016: 13.

FWI at the start 7.3
Minimum humidity 25 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Linkou County fire, March 2019
1,847 ha 1 day FWI 14.2 Min. humidity 29 % 168 km away, in 2019

First rain (1 mm or more) after it ended: 1.9 mm on 20 Mar.

What happened to them

Fires in the area that started in similar weather: 13. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
57km/h · max. gust

It was considered over on 28 Feb, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 9 Feb 2019
After · 7 Mar 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 172Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Russia

Frequently asked questions

How long did the Khankaysky District fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 16 February 2019 to 28 February 2019 (13 days). The perimeter dates it from 21 February 2019 to 27 February 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,479 hectares (44.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Khankaysky District (3,744 ha, 1.4 %); Пограничный район (729 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 7.7 °C, humidity dropped to 10 % and gusts hit 57 km/h. The fire danger index (FWI) reached 11, class Low.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Russia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 27 February 2019 → 28 February 2019.
  2. Start date: 21 February 2019 → 16 February 2019.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 21 February 2019 to 27 February 2019. 172 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.