Skip to content
worldfires
GN · Guinea · –

Kansangui fire, November 2026 Kolangui, Kansangui, Kolet

Out · last detection 11 Nov 2026, 14:24 UTC

Satellites first detected fire on 1 November 2026 in Kansangui, Guinea. It was active for 10 days, with 191 heat detections and an area with fire of about 2,464 hectares rebuilt from them, spread across 7 municipalities.

GWIS near-real-time perimeter, from the layer that changed in August 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

Compare with…

Suggestions: Kolangui · 2026Teguereyah · 2020

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 2,464ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
1 Nov 2026 – 10 Nov 2026
Municipalities hit
7
sub-prefectures
Started on
1 Nov
2026
Heat detections
191
in a single hotspot: 70 MW
Danger at start
4
Very low · FWI index
Average daily power
231MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 1 Nov10 Nov
11 Nov 2026

How it evolved, day by day

1 Nov 2026 · 27 MW · 4 2 Nov 2026 · 60 MW · 8 3 Nov 2026 · 61 MW · 6 4 Nov 2026 · 6 MW · 1 5 Nov 2026 · 77 MW · 12 6 Nov 2026 · 338 MW · 45 7 Nov 2026 · 651 MW · 52 8 Nov 2026 · 360 MW · 41 9 Nov 2026 · 590 MW · 56 10 Nov 2026 · 310 MW · 39 11 Nov 2026 · 65 MW · 24
1 Nov 4 Nov 7 Nov 10 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
30km/h · peak gust
29%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

What happened to each town

  1. 686 ha reached on 5 Nov
    1.8 %
  2. 672 ha reached on 1 Nov
    1.5 %
  3. 462 ha reached on 1 Nov
    0.3 %
  4. 336 ha reached on 1 Nov
    0.5 %
  5. Koïn where it started
    294 ha reached on 1 Nov
    1.3 %
  6. 28 ha reached on 9 Nov
    0.1 %
  7. 0 ha reached on 8 Nov
    0.0 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Nov 28.0 °C 61 % 26 km/h 1.1 mm Very low 4
2 Nov 30.3 °C 41 % 21 km/h 0.0 mm Low 8
3 Nov 30.6 °C 37 % 22 km/h 0.0 mm Moderate 14
4 Nov 28.0 °C 57 % 19 km/h 0.0 mm Low 9
5 Nov 30.7 °C 41 % 30 km/h 0.0 mm Moderate 15
6 Nov 32.2 °C 36 % 30 km/h 0.0 mm Moderate 17
7 Nov 32.0 °C 34 % 27 km/h 0.0 mm Moderate 20
8 Nov 31.5 °C 34 % 26 km/h 0.0 mm High 21
9 Nov 30.8 °C 32 % 25 km/h 0.0 mm High 21
10 Nov 31.9 °C 29 % 23 km/h 0.0 mm Moderate 21
11 Nov after 31.6 °C 28 % 21 km/h 0.0 mm High 25
12 Nov after 31.8 °C 28 % 31 km/h 0.0 mm High 29
13 Nov after 31.4 °C 34 % 21 km/h 0.0 mm Moderate 21
14 Nov after 30.3 °C 36 % 25 km/h 0.0 mm High 24
15 Nov after 30.5 °C 41 % 29 km/h 0.3 mm High 24

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Oct 2026
After · 14 Nov 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 9 November 2026 the air beside the fire reached 65 µg/m³ of PM2.5. That day averaged 46: 3.0 times the WHO daily guideline (15).

PM2.5 peak65 µg/m³
Days over the guideline11 days
PM10101 µg/m³
Optical depth0.50
29 Oct1 Nov4 Nov7 Nov
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 191Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Guinea

Frequently asked questions

How long did the Kansangui fire last?
According to the heat detections seen by satellite, it burned from 1 November 2026 to 10 November 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no perimeter yet. Heat detections rebuild about 2,464 hectares with fire (24.6 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
Which municipalities burned?
The fire entered 7 municipalities: Kolangui (686 ha, 1.8 %); Kansangui (672 ha, 1.5 %); Kolet (462 ha, 0.3 %); Tougue Ctre (336 ha, 0.5 %); Koïn (294 ha, 1.3 %); Tangali (28 ha, 0.1 %); Teguereyah (0 ha, 0.0 %).
Is the Kansangui fire still active?
No fire detections since 11 Nov 2026, 14:24 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 32.2 °C, humidity dropped to 29 % and gusts hit 30 km/h. The fire danger index (FWI) reached 21, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Guinea (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 4 Changes in area, dates, name, official record or merged pages, compared every night since 10 November 2026.
  1. Last day with fire: 9 November 2026 → 10 November 2026.
  2. Area: ≈ 3,430 → ≈ 2,464 ha.
  3. Start date: 31 October 2026 → 1 November 2026.
  4. Page published (≈ 3,430 ha).

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • No perimeter yet: the area (≈ 2,464 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 191 Suomi-NPP VIIRS detections on those dates.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.