Skip to content
worldfires
NA · Namibia · →

Kamanjab fire, 14 October 2026 Kamanjab

Out · last detection 16 Oct 2026, 00:37 UTC

The fire started on 14 October 2026 in Kamanjab, Namibia, and satellites saw it burning for 3 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,353 hectares from heat detections, spread across a single municipality.

It is the 53th largest in Kunene since 2016 (of 62 with a page). Number 118 in Namibia in 2026, of 153.

The power measured by the satellite is low (28.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
2,353ha
GWIS perimeter (Copernicus)
Duration
3days
14 Oct 2026 – 16 Oct 2026
Municipalities hit
1
constituencies
Started on
14 Oct
2026
Heat detections
42
in a single hotspot: 28 MW
Danger at start
39
Very high · FWI index
Energy released
451MW
sum of detected power

Where it burned

16 Oct 2026
HOTSPOTS BY DAY 14 Oct16 Oct

How it evolved, day by day

141516

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
54km/h · peak gust
10%lowest humidity

It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 2.3 mm on 18 Oct.

This area had burned before

69% of the perimeter overlaps earlier fires recorded since 2016: 336 ha in 2021, 1,576 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 1,625 ha that had burned before.

What happened to each town

  1. Kamanjab where it started
    2,358 ha reached on 14 Oct
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Oct 33.1 °C 15 % 40 km/h 0.0 mm Very high 39
15 Oct 35.9 °C 10 % 43 km/h 0.0 mm Very high 48
16 Oct 36.1 °C 12 % 54 km/h 0.0 mm Extreme 55
17 Oct after 35.8 °C 11 % 42 km/h 0.0 mm Extreme 52
18 Oct after 31.9 °C 20 % 41 km/h 2.3 mm High 29

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Oct 2026
After · 23 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 17 October 2026 the air beside the fire reached 23 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline0 days
PM1026 µg/m³
Optical depth0.68
121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 42Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Namibia ›

Frequently asked questions

How long did the Kamanjab fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 14 October 2026 to 16 October 2026 (3 days). The perimeter dates it from 15 October 2026 to 16 October 2026.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,353 hectares (23.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Kamanjab (2,358 ha, 0.1 %).
Is the Kamanjab fire still active?
No fire detections since 16 Oct 2026, 00:37 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 36.1 °C, humidity dropped to 10 % and gusts hit 54 km/h. The fire danger index (FWI) reached 55, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Namibia (OCHA COD-AB). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from OCHA COD-AB (Namibia Statistics Agency (NSA)) (Creative Commons Attribution for Intergovernmental Organisations (CC BY-IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.