Skip to content
worldfires
RU · Russia · –

Качугский район fire, 7 September 2016 Качугский район, Казачинско-Ленский район, Жигаловский район

Out · last detection

The fire started on in Качугский район, Russia, and satellites saw it burning for 23 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,187 hectares from heat detections, spread across 3 municipalities.

It is number 234 by size of the 421 fires with a page that started in Irkutsk Oblast since 2016. Number 400 in Russia in 2016, of 692.

Burnt area
5,187ha
GWIS perimeter (Copernicus)
Duration
23days
7 Sept 2016 – 29 Sept 2016
Municipalities hit
3
districts
Started on
7 Sept
2016
Heat detections
949
in a single hotspot: 331 MW
Danger at start
10
Low · FWI index
Average daily power
284MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 7 Sept29 Sept
29 Sept 2016

How it evolved, day by day

7 Sept 2016 · 1 MW · 1 9 Sept 2016 · 2 MW · 1 10 Sept 2016 · 21 MW · 10 11 Sept 2016 · 147 MW · 42 12 Sept 2016 · 111 MW · 37 13 Sept 2016 · 25 MW · 10 14 Sept 2016 · 84 MW · 17 15 Sept 2016 · 66 MW · 17 16 Sept 2016 · 175 MW · 38 17 Sept 2016 · 1,216 MW · 128 18 Sept 2016 · 2,196 MW · 132 19 Sept 2016 · 377 MW · 85 20 Sept 2016 · 168 MW · 57 21 Sept 2016 · 121 MW · 24 22 Sept 2016 · 40 MW · 15 23 Sept 2016 · 98 MW · 28 24 Sept 2016 · 122 MW · 23 25 Sept 2016 · 48 MW · 19 26 Sept 2016 · 100 MW · 32 27 Sept 2016 · 304 MW · 82 28 Sept 2016 · 566 MW · 116 29 Sept 2016 · 272 MW · 35
7 Sept 13 Sept 18 Sept 23 Sept 28 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

20°high
46km/h · peak gust
14%lowest humidity

It had gone 7 days without rain (1 mm or more) when it started. Rain came after the fire: 1.7 mm on 30 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 3.3% of the area of London (52 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. 3,722 ha reached on 7 Sept
    0.1 %
  2. 1,448 ha reached on 17 Sept
    0.0 %
  3. 32 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
7 Sept 18.5 °C 37 % 23 km/h 0.0 mm Low 10
8 Sept 19.6 °C 37 % 15 km/h 0.0 mm Low 8
9 Sept 18.8 °C 42 % 19 km/h 0.0 mm Low 10
10 Sept 20.4 °C 40 % 15 km/h 0.0 mm Low 9
11 Sept 20.3 °C 35 % 19 km/h 0.0 mm Low 10
12 Sept 18.3 °C 35 % 26 km/h 0.0 mm Moderate 12
13 Sept 14.0 °C 44 % 33 km/h 0.0 mm Moderate 14
14 Sept 16.0 °C 35 % 29 km/h 0.0 mm Moderate 13
15 Sept 17.5 °C 36 % 20 km/h 0.0 mm Moderate 12
16 Sept 18.8 °C 31 % 19 km/h 0.0 mm Low 11
17 Sept 18.7 °C 23 % 31 km/h 0.0 mm Moderate 16
18 Sept 19.4 °C 24 % 34 km/h 0.0 mm Moderate 19
19 Sept 20.3 °C 31 % 25 km/h 0.0 mm Moderate 16
20 Sept 16.4 °C 45 % 37 km/h 0.0 mm Moderate 17
21 Sept 13.7 °C 44 % 31 km/h 0.0 mm Moderate 17
22 Sept 12.3 °C 44 % 30 km/h 0.0 mm Moderate 15
23 Sept 9.8 °C 44 % 36 km/h 0.0 mm Low 11
24 Sept 8.7 °C 34 % 23 km/h 0.0 mm Low 11
25 Sept 5.9 °C 30 % 40 km/h 0.0 mm Moderate 16
26 Sept 6.7 °C 24 % 17 km/h 0.0 mm Low 11
27 Sept 9.7 °C 14 % 24 km/h 0.0 mm Moderate 15
28 Sept 10.5 °C 35 % 24 km/h 0.0 mm Moderate 15
29 Sept 10.0 °C 39 % 46 km/h 0.0 mm High 22
30 Sept after 2.5 °C 60 % 30 km/h 1.7 mm Very low 4

Its twins: fires that started in the same weather

It started with an FWI of 9.9, a minimum humidity of 37% and 7 days without rain. Fires in the area that started in weather like this since 2016: 17.

FWI at the start 9.9
Minimum humidity 37 %
Days without rain 7
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Качугский район fire, June 2017
5,482 ha 12 days FWI 6.8 Min. humidity 37 % 105 km away, in 2017

First rain (1 mm or more) after it ended: 10.4 mm on 2 Jul.

What happened to them

17 days
median duration
4,202 ha
median area
18 %
went past 10,000 ha
11.9 mm
rain at the end (median; 17 of 17 had it)

It burned an area similar to its twins (5,187 ha against a median of 4,202 ha) and lasted 23 days, against 17 days.

All of them had rain in the ten days after the end: the first rainy day brought a median of 11.9 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.7 mmfirst rain
30 Septthe day after it ended
46km/h · max. gust

It was considered over on 29 Sept, and on 30 Sept 1.7 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 17 of 17, with a median of 11.9 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 31 Aug 2016
After · 6 Oct 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 949Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Russia

Frequently asked questions

How long did the Качугский район fire last?
GWIS (Copernicus) dates it between 7 September 2016 and 29 September 2016: 23 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,187 hectares (51.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Качугский район (3,722 ha, 0.1 %); Казачинско-Ленский район (1,448 ha, 0.0 %); Жигаловский район (32 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 20.4 °C, humidity dropped to 14 % and gusts hit 46 km/h. The fire danger index (FWI) reached 22, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Russia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 17 days and their median area 4,202 ha; 18 % went past 10,000 ha. All of them had rain in the ten days after the end: the first rainy day brought a median of 11.9 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 949 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.