Skip to content
worldfires
RO · Romania · →

Jurilovca fire, September 2020 Jurilovca

Out · last detection 14 Sept 2020, 10:07 UTC

The fire started on 11 September 2020 in Jurilovca, Romania, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 168 hectares from satellite imagery, spread across a single municipality.

This record is fire in the reed beds of the Danube Delta, not a forest fire. Thousands of hectares of reed burn in the delta every year, mostly between January and April, and many of these burns are deliberate. That is why it is left out of the fire rankings.

The power measured by the satellite is low (26.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
168ha
Copernicus perimeter
Duration
4days
11 Sept 2020 – 14 Sept 2020
Municipalities hit
1
municipalities
Started on
11 Sept
2020
Heat detections
2
in a single hotspot: 26 MW
Danger at start
28
High · FWI index
Average daily power
41MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 11 Sept14 Sept

How it evolved, day by day

14 Sept 2020 · 41 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
45km/h · peak gust
42%lowest humidity

It had gone 6 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Jurilovca 3,694 inhabitants · 10.6 km from the centre where it started
    168 ha reached on 14 Sept
    0.6 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land78 %
  • Agricultural areas22 %

Natura 2000 protected area affected: 31 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
11 Sept 28.0 °C 42 % 36 km/h 0.0 mm High 28
12 Sept 28.5 °C 42 % 45 km/h 0.0 mm High 32
13 Sept 28.1 °C 26 % 34 km/h 0.0 mm High 32
14 Sept 30.1 °C 35 % 39 km/h 0.0 mm High 34
15 Sept after 27.5 °C 42 % 38 km/h 0.0 mm High 32
16 Sept after 28.6 °C 46 % 36 km/h 0.0 mm High 29
17 Sept after 27.2 °C 49 % 21 km/h 0.0 mm High 22
18 Sept after 21.4 °C 32 % 53 km/h 0.0 mm High 37
19 Sept after 19.7 °C 38 % 35 km/h 0.0 mm High 30
20 Sept after 23.4 °C 32 % 30 km/h 0.0 mm High 27
21 Sept after 24.8 °C 38 % 29 km/h 0.0 mm High 27
22 Sept after 23.6 °C 39 % 32 km/h 0.0 mm High 27

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 4 Sept 2020
After · 21 Sept 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 September 2020 the air beside the fire reached 16 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak16 µg/m³
Days over the guideline0 days
PM1021 µg/m³
9101112131415
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Romania ›

Frequently asked questions

How long did the Jurilovca fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 11 September 2020 to 14 September 2020 (4 days). The perimeter dates it from 11 September 2020 to 12 September 2020.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 168 hectares (1.7 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Jurilovca (168 ha, 0.6 %).
Did the fire reach a town?
The fire started in Jurilovca and came within 10.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 28.5 °C, humidity dropped to 42 % and gusts hit 45 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Romania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 11 September 2020 to 12 September 2020. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Probably a vegetation burn: not counted in the totals.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.