Jalpan de Serra fire, May 2019
Jalpan de Serra, Landa de Matamoros
Out · last detection 28 May 2019, 20:15 UTC
The fire started on 10 May 2019 in Jalpan de Serra, Mexico, and satellites saw it burning for 19 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,729 hectares from heat detections, spread across 2 municipalities.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
3,729ha
Perimeter published by GWIS (Copernicus).
This page3,729CONAFOR2,195
Source
GWIS (Copernicus)
Date
10 May 2019 – 28 May 2019
+− cross-check
CONAFOR: 2,195 ha (matched records: 1). Difference between the page and the official record: +69.9%. Matched on 15 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
19days
10 May 2019 to 28 May 2019: first and last day with fire on the page.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 28 May 2019, 20:15 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
10 May 2019
First day with fire seen by the satellites or the perimeter.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
10 May 2019
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Hotspots
satellite only
279
VIIRS detections at 375 m. Most intense hotspot: 152 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
10 May 2019 – 28 May 2019
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
1,322MW
Total radiative power on 21 May 2019; hotspots that day: 83.
Source
NASA FIRMS · VIIRS (FRP)
Date
21 May 2019
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
5.4FWI · low
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 2.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
31.2°C · 48% RH
High of 31.2 °C and minimum humidity of 48% on 18 May 2019; gusts of 35 km/h on 14 May 2019.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official CONAFOR record
Nearby records with very different figures: 2,195 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2020
Built-up area< 0.1ha
Residents< 20
Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
According to CONAFOR, this fire started on 18 May 2019 and burned 2,195 ha (the satellite measured 3,729 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Jalpan de SerraEl Cañon, San Juan de los Duran, valle Verde y Las Lagunitas18 May 20192,195 ha· extinguished on 3 June 2019· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
10 May
26.1 °C
65 %
35 km/h
0.9 mm
Low 5
11 May
26.0 °C
67 %
34 km/h
0.3 mm
Low 7
12 May
24.9 °C
71 %
34 km/h
0.9 mm
Very low 5
13 May
24.1 °C
73 %
34 km/h
2.1 mm
Very low 3
14 May
25.5 °C
71 %
35 km/h
4.0 mm
Very low 1
15 May
22.3 °C
80 %
27 km/h
9.0 mm
Very low 0
16 May
24.8 °C
70 %
28 km/h
2.4 mm
Very low 0
17 May
28.2 °C
58 %
29 km/h
0.0 mm
Very low 1
18 May
31.2 °C
48 %
31 km/h
0.0 mm
Very low 4
19 May
29.2 °C
60 %
34 km/h
0.0 mm
Low 8
20 May
28.7 °C
61 %
30 km/h
3.3 mm
Very low 1
21 May
30.8 °C
59 %
27 km/h
0.0 mm
Very low 5
22 May
29.0 °C
60 %
32 km/h
0.0 mm
Low 7
23 May
26.7 °C
62 %
30 km/h
3.2 mm
Very low 1
24 May
25.1 °C
62 %
31 km/h
1.4 mm
Very low 2
25 May
24.9 °C
65 %
31 km/h
1.2 mm
Very low 2
26 May
25.6 °C
63 %
33 km/h
0.6 mm
Very low 4
27 May
26.6 °C
55 %
34 km/h
0.3 mm
Low 6
28 May
26.6 °C
57 %
31 km/h
0.0 mm
Low 8
29 May after
27.5 °C
61 %
33 km/h
0.1 mm
Low 8
30 May after
26.9 °C
65 %
39 km/h
4.3 mm
Low 5
Its twins: fires that started in the same weather
It started with an FWI of 5.4, a minimum humidity of 65% and 2 days without rain. Fires in the area that started in weather like this since 2016: 2.
FWI at the start5.4
Minimum humidity65 %
Days without rain2
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Jalpan de Serra fire, May 2019
3,729 ha19 daysFWI 5.4Min. humidity 65 %
Zontecomatlán de López y Fuentes fire, June 2019
2,042 ha12 daysFWI 0.9Min. humidity 63 %139 km away, in 2019
First rain (1 mm or more) after it ended: 2.0 mm on 19 Jun.
Fires in the area that started in similar weather: 2. With fewer than 15 we give no figures: they would be more noise than signal.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
4.3 mmfirst rain
30 May2 days after it ended
35km/h · max. gust
It was considered over on 28 May, and on 30 May 4.3 mm fell. We do not know whether the rain or the firefighters put it out.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
According to the heat detections seen by satellite inside the perimeter, it burned from 10 May 2019 to 28 May 2019 (19 days). The perimeter dates it from 17 May 2019 to 28 May 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,729 hectares (37.3 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Jalpan de Serra (3,638 ha, 3.0 %); Landa de Matamoros (112 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 31.2 °C, humidity dropped to 48 % and gusts hit 35 km/h. The fire danger index (FWI) reached 8, class Low.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
Dates adjusted with the VIIRS detections inside the perimeter, which said 17 May 2019 to 28 May 2019. 279 Suomi-NPP VIIRS detections on those dates.
Compared with CONAFOR: 2,195 official ha against 3,729 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.