Skip to content
worldfires
ML · Mali · →

Inékar fire, April 2026 Inékar

Out · last detection 25 Apr 2026, 02:01 UTC

The fire started on 23 April 2026 in Inékar, Mali, and satellites saw it burning for 3 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,815 hectares from heat detections, spread across a single municipality.

It is the 13th largest in Gao since 2016 (of 135 with a page). Number 12 in Mali in 2026, of 116.

The power measured by the satellite is low (21.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
5,815ha
GWIS perimeter (Copernicus)
Duration
3days
23 Apr 2026 – 25 Apr 2026
Municipalities hit
1
communes
Started on
23 Apr
2026
Heat detections
134
in a single hotspot: 22 MW
Danger at start
96
Very extreme · FWI index
Energy released
564MW
sum of detected power

Where it burned

25 Apr 2026
HOTSPOTS BY DAY 23 Apr25 Apr

How it evolved, day by day

232425

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

42°high
48km/h · peak gust
5%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Inékar where it started
    5,842 ha reached on 23 Apr
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Apr 40.8 °C 7 % 48 km/h 0.0 mm Very extreme 96
24 Apr 41.1 °C 5 % 27 km/h 0.0 mm Extreme 67
25 Apr 42.1 °C 5 % 38 km/h 0.0 mm Very extreme 81
26 Apr after 42.7 °C 6 % 23 km/h 0.0 mm Extreme 67
27 Apr after 39.9 °C 15 % 39 km/h 0.0 mm Very extreme 70
28 Apr after 41.5 °C 15 % 21 km/h 0.0 mm Extreme 58
29 Apr after 42.6 °C 10 % 24 km/h 0.0 mm Extreme 62
30 Apr after 42.7 °C 7 % 37 km/h 0.0 mm Very extreme 75
1 May after 43.1 °C 4 % 47 km/h 0.0 mm Very extreme 90
2 May after 44.2 °C 6 % 42 km/h 0.0 mm Very extreme 82
3 May after 44.5 °C 7 % 37 km/h 0.0 mm Very extreme 78
4 May after 44.9 °C 7 % 28 km/h 0.0 mm Very extreme 71
5 May after 44.8 °C 5 % 31 km/h 0.0 mm Very extreme 77

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Apr 2026
After · 2 May 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 April 2026 the air beside the fire reached 91 µg/m³ of PM2.5. That day averaged 48: 3.2 times the WHO daily guideline (15).

PM2.5 peak91 µg/m³
Days over the guideline8 days
PM10604 µg/m³
Optical depth0.76
2122232425262728
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 134Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mali ›

Frequently asked questions

How long did the Inékar fire last?
GWIS (Copernicus) dates it between 23 April 2026 and 25 April 2026: 3 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,815 hectares (58.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Inékar (5,842 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 42.1 °C, humidity dropped to 5 % and gusts hit 48 km/h. The fire danger index (FWI) reached 96, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mali (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.