Skip to content
worldfires
US · United States · →

Grass Burr Fire, August 2026 Cottle

Out · last detection 13 Aug 2026, 20:44 UTC

The fire started on 13 August 2026 in Cottle, United States, and satellites saw it burning for 1 day. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 1,062 hectares, spread across a single county.

It is the 162th largest in Texas since 2016 (of 327 with a page). Number 255 in United States in 2026, of 423.

Compare with…
Burnt area
1,062ha
official perimeter (MTBS / NIFC)
Duration
≈ 1day
13 Aug 2026 – 13 Aug 2026
Counties hit
1
counties
Started on
13 Aug
2026
Heat detections
61
in a single hotspot: 92 MW
Danger at start
61
Extreme · FWI index
Average daily power
1.6GW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 13 Aug13 Aug

How it evolved, day by day

13 Aug 2026 · 1,562 MW · 61

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

41°high
51km/h · peak gust
22%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

This area had burned before

13% of the perimeter overlaps earlier fires recorded since 2016: 140 ha in 2019.

How big is it?

10 km
It burned the equivalent of 0.7% of the area of London (11 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each county

  1. Cottle where it started
    1,061 ha reached on 13 Aug
    0.4 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Aug 41.1 °C 22 % 51 km/h 0.0 mm Extreme 61
14 Aug after 39.8 °C 19 % 48 km/h 0.0 mm Extreme 68
15 Aug after 39.3 °C 22 % 46 km/h 0.0 mm Extreme 61
16 Aug after 39.0 °C 18 % 38 km/h 0.0 mm Extreme 56
17 Aug after 39.8 °C 16 % 31 km/h 0.0 mm Extreme 53
18 Aug after 41.2 °C 14 % 39 km/h 0.0 mm Extreme 59
19 Aug after 40.9 °C 14 % 42 km/h 0.0 mm Extreme 60
20 Aug after 41.3 °C 15 % 37 km/h 0.0 mm Extreme 61
21 Aug after 40.8 °C 17 % 34 km/h 0.0 mm Extreme 58
22 Aug after 41.5 °C 15 % 34 km/h 0.7 mm Extreme 57
23 Aug after 40.9 °C 15 % 26 km/h 0.0 mm Extreme 52

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Aug 2026
After · 20 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 16 August 2026 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak15 µg/m³
Days over the guideline0 days
PM1021 µg/m³
Optical depth0.16
111213141516
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 61Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States ›

Frequently asked questions

How long did the Grass Burr Fire last?
The official perimeter only gives the start date (13 August 2026). The end comes from the heat detections inside the perimeter: it burned until 13 August 2026 (1 day from 13 August 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 1,062 hectares (10.6 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire only entered Cottle (1,061 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 41.1 °C, humidity dropped to 22 % and gusts hit 51 km/h. The fire danger index (FWI) reached 61, class Extreme.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: NIFC WFIGS (United States), official.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 61 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.