Skip to content
worldfires
ES · Spain · →

Fuertescusa fire, August 2022 Fuertescusa, Cañamares

Out · last detection 11 Aug 2022, 02:56 UTC

The fire started on 10 August 2022 in Fuertescusa, Spain, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 235 hectares from satellite imagery, spread across 2 municipalities.

Number 104 in Spain in 2022, of 192.

The power measured by the satellite is low (0.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Suggestions: Cañamares · 2017Ocentejo · 2023

Burnt area
235ha
Copernicus perimeter
Duration
2days
10 Aug 2022 – 11 Aug 2022
Municipalities hit
2
municipalities
Started on
10 Aug
2022
Heat detections
1
in a single hotspot: 1 MW
Danger at start
52
Extreme · FWI index
Average daily power
1MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Aug11 Aug

How it evolved, day by day

11 Aug 2022 · 1 MW · 1

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
40km/h · peak gust
14%lowest humidity

It had gone 10 days without rain (1 mm or more) when it started. Rain came after the fire: 3.2 mm on 17 Aug.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Fuertescusa 441 inhabitants · 5.9 km from the centre where it started
    136 ha reached on 11 Aug
    2.1 %
  2. Cañamares 457 inhabitants · 2.4 km from the centre
    99 ha
    2.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Coniferous forest86 %
  • Other natural land7.7 %
  • Agricultural areas4.3 %
  • Mixed forest2.6 %

Natura 2000 protected area affected: 93 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to EGIF (MITECO), this fire started on 10 August 2022 and burned 385 ha (the satellite measured 235 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

MITECO, Estadística General de Incendios Forestales (EGIF). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Aug 33.8 °C 14 % 40 km/h 0.3 mm Extreme 52
11 Aug 33.5 °C 17 % 38 km/h 0.0 mm Extreme 52
12 Aug after 33.4 °C 21 % 44 km/h 0.4 mm Extreme 61
13 Aug after 25.7 °C 31 % 58 km/h 0.4 mm Extreme 51
14 Aug after 28.7 °C 15 % 53 km/h 0.0 mm Extreme 57
15 Aug after 27.8 °C 18 % 41 km/h 0.0 mm Very high 42
16 Aug after 26.5 °C 22 % 52 km/h 0.0 mm Very high 49
17 Aug after 24.1 °C 27 % 37 km/h 3.2 mm Low 9

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Aug 2022
After · 18 Aug 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 12 August 2022 the air beside the fire reached 24 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak24 µg/m³
Days over the guideline0 days
PM1087 µg/m³
Optical depth0.49
891011121314
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Fuertescusa fire last?
Copernicus dates it between 10 August 2022 and 11 August 2022: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 235 hectares (2.4 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Fuertescusa (136 ha, 2.1 %); Cañamares (99 ha, 2.4 %).
Did the fire reach a town?
The fire came within 2.4 km of the centre of Cañamares, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 33.8 °C, humidity dropped to 14 % and gusts hit 40 km/h. The fire danger index (FWI) reached 52, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. One Suomi-NPP VIIRS detection on those dates.
  • Compared with EGIF (MITECO): 385 official ha against 235 ha of perimeter; similar, but with reservations.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.