Skip to content
worldfires
CM · Cameroon · –

Fonfuka fire, November 2026 Furu-Awa, Misaje, Fonfuka

Dying down · last detection 16 Nov 2026, 13:31 UTC

Satellites first detected fire on 11 November 2026 in Fonfuka, Cameroon. It has been active for 6 days, with 96 heat detections and an area with fire of about 1,218 hectares rebuilt from them, spread across 4 municipalities.

GWIS near-real-time perimeter, from the layer that changed in August 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

The power measured by the satellite is low (15.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

No detections since 16 Nov 2026, 13:31 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Area with fire
≈ 1,218ha
rebuilt from hotspots, no official perimeter yet
Duration
6days
11 Nov 2026 – 16 Nov 2026
Municipalities hit
4
communes
Started on
11 Nov
2026
Heat detections
96
in a single hotspot: 15 MW
Danger at start
1
Very low · FWI index
Average daily power
85MW
detected power per day, on average

The next 72 hours

The wind is blowing from the north and pushing southwards; no sharp shifts are expected until Fri 20, 12:00.

ECMWF IFS 0.25° at the centre of the fire · computed 17 Nov 2026, 11:22 UTC

No sharp changes in the next 72 h

No strong wind shifts and no dry nights. No warnings does not mean the fire will go out: in this weather it can carry on as it is.

Checked, no warning: no wind shifts of more than 60° nights recover humidity (peaks of 78 % or more) no useful rain expected (0.0 mm in 72 h)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/OpenStreetMap, Wambacher (Open Data Commons Open Database License 1.0); geoBoundaries/GRID3 (Creative Commons Attribution 4.0 International (CC BY 4.0))

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: VIIRS (NASA FIRMS); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/OpenStreetMap, Wambacher (Open Data Commons Open Database License 1.0); geoBoundaries/GRID3 (Creative Commons Attribution 4.0 International (CC BY 4.0)).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 11 Nov16 Nov
    16 Nov 2026

    How it evolved, day by day

    11 Nov 2026 · 40 MW · 8 12 Nov 2026 · 21 MW · 5 13 Nov 2026 · 54 MW · 10 14 Nov 2026 · 3 MW · 1 15 Nov 2026 · 208 MW · 37 16 Nov 2026 · 182 MW · 35
    11 Nov 13 Nov 15 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    Fire front film How it spread from one satellite pass to the next (13 passes) and with what wind. Watch the film

    The weather it burned in

    29°high
    31km/h · peak gust
    37%lowest humidity

    It had gone 0 days without rain (1 mm or more) when it started.

    What happened to each town

    1. 616 ha reached on 11 Nov
      0.5 %
    2. 322 ha reached on 11 Nov
      0.4 %
    3. Fonfuka where it started
      266 ha reached on 11 Nov
      0.4 %
    4. 14 ha reached on 15 Nov
      0.0 %

    Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Day High Min. humidity Peak gust Rain Danger (FWI)
    11 Nov 26.9 °C 53 % 30 km/h 0.3 mm Very low 1
    12 Nov 26.8 °C 51 % 28 km/h 1.4 mm Low 6
    13 Nov 26.7 °C 51 % 25 km/h 0.2 mm Low 5
    14 Nov 27.1 °C 55 % 31 km/h 0.9 mm Low 9
    15 Nov 29.3 °C 37 % 28 km/h 0.0 mm Moderate 12
    16 Nov 29.4 °C 38 % 27 km/h 0.0 mm Moderate 14
    17 Nov after 27.8 °C 41 % 28 km/h 0.0 mm Moderate 14

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 4 Nov 2026
    After · 16 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    The smoke

    CAMS · Copernicus

    On 16 November 2026 the air beside the fire reached 37 µg/m³ of PM2.5. That day averaged 26: 1.7 times the WHO daily guideline (15).

    PM2.5 peak37 µg/m³
    Days over the guideline8 days
    PM1065 µg/m³
    Optical depth0.55
    9 Nov11 Nov13 Nov15 Nov
    Good Fair Moderate Poor Very poor Extremely poor

    Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

    Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

    Cities with smoke from this fire

    According to the CAMS forecast and the wind at 850 hPa, this fire is today the most likely main source of smoke in:

    1. 34 µg Smoke today in Belo ×2.2 the WHO guideline today · 52 % of the upwind weight · 43 km away

    An estimate without a dispersion model, based on a model forecast: not a measurement.

    Detections table · 96Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Other fires nearby

    All fires in Cameroon

    Frequently asked questions

    How long did the Fonfuka fire last?
    According to the heat detections seen by satellite, it burned from 11 November 2026 to 16 November 2026 (6 days between the first and the last detection). There is no perimeter yet to date it.
    How much area did it burn?
    There is no perimeter yet. Heat detections rebuild about 1,218 hectares with fire (12.2 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
    Which municipalities burned?
    The fire entered 4 municipalities: Furu-Awa (616 ha, 0.5 %); Misaje (322 ha, 0.4 %); Fonfuka (266 ha, 0.4 %); Zhoa (14 ha, 0.0 %).
    Is the Fonfuka fire still active?
    No fire detections since 16 Nov 2026, 13:31 UTC. A lack of detections is not an official extinction.
    What was the weather like?
    During the fire the temperature reached 29.4 °C, humidity dropped to 37 % and gusts hit 31 km/h. The fire danger index (FWI) reached 14, class Moderate.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the north and pushing southwards; no sharp shifts are expected until Fri 20, 12:00. No strong wind shifts, dry nights or useful rain are expected. Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 17 Nov 2026, 11:22 UTC; this is not an official warning.
    Where does this data come from?
    From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Cameroon (geoBoundaries). It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Satellite cross-check

    History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 17 November 2026.
    1. Page published (≈ 1,218 ha).

    RSS Changes to this page With cross-checks and a citable version

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy.

    How we know this
    • No perimeter yet: the area (≈ 1,218 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
    • Dates of the first and last VIIRS detection of the cluster. 96 Suomi-NPP VIIRS detections on those dates.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.