Skip to content
worldfires
IT · Italy · →

Deliceto fire, October 2026 Foggia, Sant'Agata di Puglia, Deliceto

Out · last detection 7 Oct 2026, 12:08 UTC

Satellites first detected fire on 4 October 2026 in Deliceto, Italy. It was active for 4 days, with 12 heat detections and an area with fire of about 168 hectares rebuilt from them, spread across 15 municipalities.

The power measured by the satellite is low (6.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 168ha
rebuilt from hotspots, no official perimeter yet
Duration
4days
4 Oct 2026 – 7 Oct 2026
Municipalities hit
15
municipalities
Started on
4 Oct
2026
Heat detections
12
in a single hotspot: 6 MW
Danger at start
10
Low · FWI index
Average daily power
19MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 4 Oct7 Oct
7 Oct 2026

How it evolved, day by day

4 Oct 2026 · 39 MW · 7 5 Oct 2026 · 4 MW · 1 6 Oct 2026 · 0 MW · 0 7 Oct 2026 · 13 MW · 4
4 Oct 5 Oct 6 Oct 7 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
42km/h · peak gust
33%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

What happened to each town

  1. Foggia 145,348 inhabitants · 3.4 km from the centre
    112 ha reached on 4 Oct
    0.2 %
  2. Sant'Agata di Puglia 1,803 inhabitants · 5.8 km from the centre
    84 ha reached on 4 Oct
    0.7 %
  3. Deliceto 3,506 inhabitants · 5.3 km from the centre where it started
    56 ha reached on 4 Oct
    0.7 %
  4. Cerignola 3,275 inhabitants · 19.2 km from the centre
    56 ha
    0.1 %
  5. Troia 6,689 inhabitants · 16.6 km from the centre
    42 ha
    0.2 %
  6. Lucera 30,975 inhabitants · 12.3 km from the centre
    28 ha reached on 4 Oct
    0.1 %
  7. 14 ha
    0.2 %
  8. Ascoli Satriano 5,863 inhabitants · 6.1 km from the centre
    14 ha reached on 5 Oct
    0.0 %
  9. Manfredonia 53,902 inhabitants · 18.0 km from the centre
    14 ha reached on 5 Oct
    0.0 %
  10. Carapelle 6,817 inhabitants · 1.1 km from the centre
    14 ha reached on 4 Oct
    0.6 %
  11. San Marco in Lamis 12,633 inhabitants · 22.4 km from the centre
    14 ha
    0.1 %
  12. San Giovanni Rotondo 26,235 inhabitants · 19.7 km from the centre
    14 ha
    0.0 %
  13. Stornarella 5,239 inhabitants · 11.2 km from the centre
    0 ha
    0.0 %
  14. Orta Nova 16,783 inhabitants · 2.6 km from the centre
    0 ha reached on 5 Oct
    0.0 %
  15. Bovino 2,973 inhabitants · 9.5 km from the centre
    0 ha
    0.0 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
20 Sept 26.0 °C 64 % 34 km/h 0.0 mm Low 10
21 Sept 26.8 °C 52 % 30 km/h 0.0 mm Moderate 16
22 Sept 24.1 °C 33 % 42 km/h 2.7 mm Moderate 12
23 Sept 21.8 °C 41 % 36 km/h 0.0 mm Moderate 19
24 Sept 26.8 °C 28 % 29 km/h 0.0 mm High 27

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Sept 2026
After · 14 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 September 2026 the air beside the fire reached 9 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak9 µg/m³
Days over the guideline0 days
PM1015 µg/m³
Optical depth0.25
181920212223
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 12Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Deliceto fire last?
According to the heat detections seen by satellite, it burned from 4 October 2026 to 7 October 2026 (4 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 168 hectares with fire (1.7 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire entered 15 municipalities: Foggia (112 ha, 0.2 %); Sant'Agata di Puglia (84 ha, 0.7 %); Deliceto (56 ha, 0.7 %); Cerignola (56 ha, 0.1 %); Troia (42 ha, 0.2 %); Lucera (28 ha, 0.1 %); Candela (14 ha, 0.2 %); Ascoli Satriano (14 ha, 0.0 %); Manfredonia (14 ha, 0.0 %); Carapelle (14 ha, 0.6 %); San Marco in Lamis (14 ha, 0.1 %); San Giovanni Rotondo (14 ha, 0.0 %).
Is the Deliceto fire still active?
No fire detections since 7 Oct 2026, 12:08 UTC. A lack of detections is not an official extinction.
Did the fire reach a town?
The fire came within 1.1 km of the centre of Carapelle, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 26.8 °C, humidity dropped to 33 % and gusts hit 42 km/h. The fire danger index (FWI) reached 19, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • No perimeter yet: the area (≈ 168 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 12 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.