Skip to content
worldfires
BO · Bolivia · –

Exaltación fire, 2 September 2020 Exaltación

Out · last detection 27 Sept 2020, 17:34 UTC

The fire started on 2 September 2020 in Exaltación, Bolivia, and satellites saw it burning for 26 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,620 hectares from heat detections, spread across a single municipality.

It is the 652th largest in Beni since 2016 (of 858 with a page). Number 159 in Bolivia in 2020, of 210.

Burnt area
3,620ha
GWIS perimeter (Copernicus)
Duration
26days
2 Sept 2020 – 27 Sept 2020
Municipalities hit
1
municipalities
Started on
2 Sept
2020
Heat detections
299
in a single hotspot: 0 MW
Danger at start
29
High · FWI index
Average daily power
158MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 2 Sept27 Sept
27 Sept 2020

How it evolved, day by day

2 Sept 2020 · 8 MW · 1 3 Sept 2020 · 13 MW · 1 4 Sept 2020 · 88 MW · 9 5 Sept 2020 · 1,937 MW · 32 6 Sept 2020 · 445 MW · 37 7 Sept 2020 · 283 MW · 41 8 Sept 2020 · 48 MW · 22 9 Sept 2020 · 92 MW · 27 10 Sept 2020 · 32 MW · 11 11 Sept 2020 · 38 MW · 8 12 Sept 2020 · 14 MW · 5 13 Sept 2020 · 27 MW · 12 14 Sept 2020 · 12 MW · 10 16 Sept 2020 · 13 MW · 1 17 Sept 2020 · 178 MW · 29 18 Sept 2020 · 31 MW · 8 19 Sept 2020 · 22 MW · 9 20 Sept 2020 · 31 MW · 11 21 Sept 2020 · 10 MW · 4 25 Sept 2020 · 83 MW · 10 26 Sept 2020 · 23 MW · 5 27 Sept 2020 · 40 MW · 6
5 Sept 12 Sept 18 Sept 26 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
45km/h · peak gust
33%lowest humidity

It had gone 12 days without rain (1 mm or more) when it started. Rain came after the fire: 16.6 mm on 28 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 2.3% of the area of London (36 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Exaltación 8,012 inhabitants where it started
    3,641 ha
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
2 Sept 32.1 °C 43 % 34 km/h 0.0 mm High 29
3 Sept 33.7 °C 40 % 26 km/h 0.0 mm High 26
4 Sept 35.7 °C 37 % 23 km/h 0.1 mm High 25
5 Sept 36.7 °C 33 % 28 km/h 0.0 mm High 33
6 Sept 36.3 °C 38 % 31 km/h 0.0 mm High 31
7 Sept 33.5 °C 45 % 32 km/h 0.4 mm High 33
8 Sept 34.2 °C 37 % 34 km/h 0.0 mm High 32
9 Sept 36.3 °C 36 % 20 km/h 0.0 mm High 25
10 Sept 37.0 °C 34 % 17 km/h 0.0 mm High 24
11 Sept 36.9 °C 36 % 34 km/h 0.0 mm High 34
12 Sept 36.2 °C 35 % 28 km/h 0.2 mm High 30
13 Sept 36.4 °C 36 % 24 km/h 0.0 mm High 31
14 Sept 31.8 °C 54 % 23 km/h 1.9 mm Low 11
15 Sept 30.9 °C 49 % 34 km/h 0.0 mm High 22
16 Sept 36.2 °C 35 % 18 km/h 0.0 mm Moderate 20
17 Sept 35.7 °C 37 % 19 km/h 0.0 mm High 22
18 Sept 32.9 °C 52 % 23 km/h 0.1 mm High 21
19 Sept 34.9 °C 40 % 29 km/h 0.0 mm High 26
20 Sept 30.1 °C 60 % 44 km/h 10.8 mm Low 6
21 Sept 29.7 °C 57 % 38 km/h 0.5 mm Low 11
22 Sept 28.4 °C 49 % 42 km/h 0.9 mm Moderate 16
23 Sept 34.3 °C 39 % 25 km/h 0.0 mm Moderate 19
24 Sept 35.0 °C 43 % 17 km/h 0.0 mm Moderate 18
25 Sept 36.7 °C 41 % 28 km/h 0.0 mm High 25
26 Sept 34.9 °C 50 % 45 km/h 0.0 mm High 34
27 Sept 35.4 °C 46 % 41 km/h 0.0 mm High 30
28 Sept after 31.5 °C 60 % 32 km/h 16.6 mm Moderate 19

Its twins: fires that started in the same weather

It started with an FWI of 28.8, a minimum humidity of 43% and 12 days without rain. Fires in the area that started in weather like this since 2016: 17.

FWI at the start 28.8
Minimum humidity 43 %
Days without rain 12
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Exaltación fire, September 2022
6,125 ha 8 days FWI 27.2 Min. humidity 42 % 66 km away, in 2022

First rain (1 mm or more) after it ended: 3.1 mm on 29 Sept.

What happened to them

8 days
median duration
5,868 ha
median area
18 %
went past 10,000 ha
3.6 mm
rain at the end (median; 14 of 17 had it)

It stayed below its twins: 3,620 ha against a median of 5,868 ha. It lasted 26 days, against 8 days.

In 3 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

16.6 mmfirst rain
28 Septthe day after it ended
45km/h · max. gust

It was considered over on 27 Sept, and on 28 Sept 16.6 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 14 of 17, with a median of 3.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Aug 2020
After · 4 Oct 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 0Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Bolivia

Frequently asked questions

How long did the Exaltación fire last?
GWIS (Copernicus) dates it between 2 September 2020 and 27 September 2020: 26 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,620 hectares (36.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Exaltación (3,641 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 37.0 °C, humidity dropped to 33 % and gusts hit 45 km/h. The fire danger index (FWI) reached 34, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Bolivia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 8 days and their median area 5,868 ha; 18 % went past 10,000 ha. In 3 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 119 · 110 · Emergency number and official warnings

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 28 August 2020 → 2 September 2020.
  2. Start date: 2 September 2020 → 28 August 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 119 · 110.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. No Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.