Skip to content
worldfires
FR · France · –

Estérençuby fire, 15 February 2019 Estérençuby, Saint-Michel

Out · last detection 20 Feb 2019, 02:30 UTC

The fire started on 15 February 2019 in Estérençuby, France, and satellites saw it burning for 6 days. Copernicus mapped a burnt perimeter of 284 hectares from satellite imagery, spread across 2 municipalities.

It is the 17th largest in Pyrénées-Atlantiques since 2016 (of 69 with a page). Number 6 in France in 2019, of 26.

The power measured by the satellite is low (12.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
284ha
Copernicus perimeter
Duration
6days
15 Feb 2019 – 20 Feb 2019
Municipalities hit
2
communes
Started on
15 Feb
2019
Heat detections
5
in a single hotspot: 12 MW
Danger at start
4
Very low · FWI index
Average daily power
22MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 15 Feb20 Feb
20 Feb 2019

How it evolved, day by day

19 Feb 2019 · 42 MW · 4 20 Feb 2019 · 1 MW · 1
19 Feb 20 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

18°high
55km/h · peak gust
19%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started.

This area had burned before

58% of the perimeter overlaps earlier fires recorded since 2016: 166 ha in 2017.

What happened to each town

  1. Estérençuby 303 inhabitants · 0.6 km from the centre where it started
    193 ha reached on 19 Feb
    4.2 %
  2. Saint-Michel 290 inhabitants · 1.8 km from the centre
    91 ha
    3.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land74 %
  • Broadleaved forest24 %
  • Agricultural areas1.8 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.19 ha
Residents< 20

Inside the perimeter there were about 0.19 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
15 Feb 16.8 °C 27 % 34 km/h 0.0 mm Very low 4
16 Feb 17.7 °C 21 % 48 km/h 0.0 mm Very low 4
17 Feb 18.0 °C 19 % 55 km/h 0.0 mm Low 10
18 Feb 15.2 °C 41 % 40 km/h 0.0 mm Low 6
19 Feb 13.8 °C 54 % 19 km/h 0.0 mm Very low 3
20 Feb 15.5 °C 51 % 24 km/h 0.0 mm Very low 4
21 Feb after 18.3 °C 39 % 28 km/h 0.0 mm Very low 4
22 Feb after 19.3 °C 33 % 24 km/h 0.0 mm Very low 4
23 Feb after 18.4 °C 32 % 36 km/h 0.0 mm Low 7
24 Feb after 18.1 °C 46 % 34 km/h 0.0 mm Low 6
25 Feb after 18.3 °C 43 % 23 km/h 0.0 mm Low 6
26 Feb after 21.2 °C 29 % 39 km/h 0.0 mm Low 7
27 Feb after 23.5 °C 19 % 26 km/h 0.0 mm Low 10
28 Feb after 14.3 °C 63 % 40 km/h 0.0 mm Low 8
1 Mar after 13.4 °C 59 % 34 km/h 0.0 mm Low 6
2 Mar after 14.4 °C 57 % 44 km/h 0.3 mm Low 7

Its twins: fires that started in the same weather

It started with an FWI of 3.6, a minimum humidity of 27% and 3 days without rain. Fires in the area that started in weather like this since 2016: 20.

FWI at the start 3.6
Minimum humidity 27 %
Days without rain 3
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Aincille fire, February 2026
121 ha 2 days FWI 2.6 Min. humidity 27 % 3 km away, in 2026

First rain (1 mm or more) after it ended: 2.0 mm on 27 Feb.

What happened to them

3 days
median duration
133 ha
median area
0 %
went past 1,000 ha
3.8 mm
rain at the end (median; 20 of 20 had it)

It was 2.1 times larger than the median of its twins and lasted 6 days, against 3 days.

Only 5 of its 20 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. All of them had rain in the ten days after the end: the first rainy day brought a median of 3.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
55km/h · max. gust

It was considered over on 20 Feb, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 20 of 20, with a median of 3.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 8 Feb 2019
After · 27 Feb 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 22 February 2019 the air beside the fire reached 34 µg/m³ of PM2.5. That day averaged 24: 1.6 times the WHO daily guideline (15).

PM2.5 peak34 µg/m³
Days over the guideline4 days
PM1053 µg/m³
17 Feb19 Feb21 Feb23 Feb
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in France

Frequently asked questions

How long did the Estérençuby fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 15 February 2019 to 20 February 2019 (6 days). The perimeter dates it from 19 February 2019 to 20 February 2019.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 284 hectares (2.8 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Estérençuby (193 ha, 4.2 %); Saint-Michel (91 ha, 3.1 %).
Did the fire reach a town?
The fire started in Estérençuby and came within 0.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 18.0 °C, humidity dropped to 19 % and gusts hit 55 km/h. The fire danger index (FWI) reached 10, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of France (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 20. Their median duration was 3 days and their median area 133 ha; 0 % went past 1,000 ha. Only 5 of its 20 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. All of them had rain in the ten days after the end: the first rainy day brought a median of 3.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 18 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 18.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 19 February 2019 to 20 February 2019. 5 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM5 (Open Data Commons Attribution License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.