Skip to content
worldfires
MX · Mexico · –

Erongarícuaro fire, April 2021 Erongarícuaro, Pátzcuaro

Out · last detection 23 Apr 2021, 19:23 UTC

The fire started on 9 April 2021 in Erongarícuaro, Mexico, and satellites saw it burning for 15 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,533 hectares from heat detections, spread across 2 municipalities.

It is the 99th largest in Michoacan de Ocampo since 2016 (of 106 with a page). Number 286 in Mexico in 2021, of 294.

The power measured by the satellite is low (23.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,533ha
GWIS perimeter (Copernicus)
Duration
15days
9 Apr 2021 – 23 Apr 2021
Municipalities hit
2
municipalities
Started on
9 Apr
2021
Heat detections
116
in a single hotspot: 24 MW
Danger at start
18
Moderate · FWI index
Average daily power
39MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 9 Apr23 Apr
23 Apr 2021

How it evolved, day by day

9 Apr 2021 · 12 MW · 2 10 Apr 2021 · 46 MW · 6 11 Apr 2021 · 21 MW · 6 12 Apr 2021 · 17 MW · 4 13 Apr 2021 · 1 MW · 1 14 Apr 2021 · 12 MW · 3 15 Apr 2021 · 142 MW · 10 16 Apr 2021 · 82 MW · 18 17 Apr 2021 · 12 MW · 3 18 Apr 2021 · 27 MW · 11 19 Apr 2021 · 43 MW · 11 20 Apr 2021 · 59 MW · 12 21 Apr 2021 · 63 MW · 14 22 Apr 2021 · 16 MW · 7 23 Apr 2021 · 25 MW · 8
9 Apr 12 Apr 15 Apr 18 Apr 21 Apr

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
52km/h · peak gust
16%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1% of the area of London (15 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Erongarícuaro where it started
    1,441 ha reached on 9 Apr
    5.9 %
  2. 99 ha reached on 23 Apr
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area4.8 ha
Residents≈ 850

Inside the perimeter there were about 4.8 hectares of built-up land and about 850 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
9 Apr 25.7 °C 28 % 45 km/h 0.0 mm Moderate 18
10 Apr 26.5 °C 25 % 42 km/h 0.0 mm High 27
11 Apr 26.6 °C 25 % 48 km/h 0.0 mm High 33
12 Apr 25.4 °C 31 % 45 km/h 0.0 mm High 34
13 Apr 27.0 °C 28 % 42 km/h 0.3 mm High 32
14 Apr 27.0 °C 23 % 40 km/h 0.1 mm High 32
15 Apr 28.0 °C 25 % 42 km/h 0.6 mm High 30
16 Apr 27.6 °C 27 % 44 km/h 0.3 mm High 31
17 Apr 25.5 °C 22 % 52 km/h 0.0 mm Very high 42
18 Apr 25.5 °C 19 % 49 km/h 0.0 mm Very high 41
19 Apr 24.8 °C 22 % 50 km/h 0.0 mm Very high 42
20 Apr 26.1 °C 18 % 47 km/h 0.0 mm Very high 43
21 Apr 26.9 °C 16 % 47 km/h 0.0 mm Very high 44
22 Apr 26.2 °C 18 % 45 km/h 0.0 mm Very high 48
23 Apr 25.8 °C 21 % 47 km/h 0.0 mm Very high 48
24 Apr after 27.4 °C 21 % 49 km/h 0.0 mm Very high 40
25 Apr after 27.7 °C 25 % 39 km/h 0.1 mm Very high 41
26 Apr after 27.8 °C 29 % 42 km/h 0.3 mm Very high 39
27 Apr after 28.5 °C 27 % 46 km/h 0.0 mm Very high 42
28 Apr after 27.6 °C 30 % 46 km/h 0.1 mm Very high 41
29 Apr after 26.7 °C 32 % 45 km/h 0.1 mm High 38
30 Apr after 25.7 °C 31 % 47 km/h 0.2 mm Very high 38
1 May after 24.9 °C 33 % 51 km/h 0.2 mm Very high 42
2 May after 25.7 °C 29 % 50 km/h 0.2 mm High 37
3 May after 24.6 °C 24 % 49 km/h 0.0 mm Very high 43

Its twins: fires that started in the same weather

It started with an FWI of 18.4, a minimum humidity of 28% and rain the day before. Fires in the area that started in weather like this since 2016: 15.

FWI at the start 18.4
Minimum humidity 28 %
Days without rain 0
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Coyuca de Catalán fire, May 2023
2,270 ha 15 days FWI 19.4 Min. humidity 28 % 197 km away, in 2023

First rain (1 mm or more) after it ended: 1.5 mm on 7 Jun.

What happened to them

10 days
median duration
2,965 ha
median area
100 %
went past 1,000 ha
1.6 mm
rain at the end (median; 14 of 15 had it)

It stayed below its twins: 1,533 ha against a median of 2,965 ha. It lasted 15 days, against 10 days.

In 1 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
52km/h · max. gust

It was considered over on 23 Apr, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 14 of 15, with a median of 1.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 2 Apr 2021
After · 30 Apr 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 116Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Erongarícuaro fire last?
GWIS (Copernicus) dates it between 9 April 2021 and 23 April 2021: 15 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,533 hectares (15.3 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Erongarícuaro (1,441 ha, 5.9 %); Pátzcuaro (99 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 28.0 °C, humidity dropped to 16 % and gusts hit 52 km/h. The fire danger index (FWI) reached 48, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 15. Their median duration was 10 days and their median area 2,965 ha; 100 % went past 1,000 ha. In 1 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 116 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.