Skip to content
worldfires
CY · Cyprus · →

Erimi fire, May 2018 Ερήμη · Erimi, Ypsonas

Out · last detection 31 May 2018, 11:38 UTC

The fire started on 31 May 2018 in Erimi, Cyprus, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 115 hectares from satellite imagery, spread across 2 municipalities.

It is the 10th largest in Limassol since 2016 (of 15 with a page). The largest in Cyprus in 2018, of 2.

The power measured by the satellite is low (27.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
115ha
Copernicus perimeter
Duration
1day
31 May 2018 – 31 May 2018
Municipalities hit
2
municipalities
Started on
31 May
2018
Heat detections
6
in a single hotspot: 27 MW
Danger at start
3
Very low · FWI index
Energy released
102MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 31 May31 May

How it evolved, day by day

31

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

26°high
37km/h · peak gust
57%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 8.5 mm on 1 Jun.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Erimi Ερήμη 2,432 inhabitants · 1.6 km from the town where it started
    99 ha reached on 31 May
    16 %
  2. Ypsonas Ύψωνας
    16 ha reached on 31 May
    0.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub97 %
  • Agricultural areas1.7 %
  • Other natural land0.9 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to Τμήμα Δασών, this fire started on 31 May 2018 and burned 180 ha (the satellite measured 115 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

Τμήμα Δασών (Departamento de Bosques de Chipre), catálogo de incendios forestales. This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 May 26.4 °C 57 % 37 km/h 4.7 mm Very low 3
1 Jun after 25.1 °C 63 % 28 km/h 8.5 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 May 2018
After · 7 Jun 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 3 June 2018 the air beside the fire reached 13 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak13 µg/m³
Days over the guideline0 days
PM1022 µg/m³
293031123
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 6Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Cyprus ›

Frequently asked questions

How long did the Erimi fire last?
Copernicus dates it between 31 May 2018 and 31 May 2018: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 115 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Erimi (99 ha, 16 %); Ypsonas (16 ha, 0.5 %).
Did the fire reach a town?
The closest fire to a town centre came within 1.6 km of Erimi. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 26.4 °C, humidity dropped to 57 % and gusts hit 37 km/h. The fire danger index (FWI) reached 3, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Cyprus (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1407

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1407.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution-ShareAlike 3.0 Unported). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.