El M'Ghair fire, October 2026
المغير · El M'Ghair, M'Naguer, Sidi Khellil
Out · last detection
Satellites first detected fire on in El M'Ghair, Algeria. It was active for 2 days, with 15 heat detections and an area with fire of about 210 hectares rebuilt from them, spread across 3 municipalities.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
satellite only
≈ 210ha
Estimated from hotspots: no perimeter has been published yet.
Source
NASA FIRMS · VIIRS
Date
2 Oct 2026 – 3 Oct 2026
+− cross-check
This is an estimate from the VIIRS pixels that saw fire. It will change when the perimeter is published.
Duration by satellite
satellite only
2days
2 Oct 2026 to 3 Oct 2026: first and last day with fire on the page.
Source
NASA FIRMS · VIIRS
Date
last detection: 3 Oct 2026, 02:02 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
2 Oct 2026
First day with fire seen by the satellites or the perimeter.
Source
NASA FIRMS · VIIRS
Date
2 Oct 2026
+− cross-check
No official record is matched to this page, so the alert time and the cause are not known here.
Hotspots
satellite only
15
VIIRS detections at 375 m. Most intense hotspot: 45 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
2 Oct 2026 – 3 Oct 2026
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
176MW
Total radiative power on 3 October 2026; hotspots that day: 13.
Source
NASA FIRMS · VIIRS (FRP)
Date
3 Oct 2026
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
37.4FWI · high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 10.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
32.5°C · 33% RH
High of 32.5 °C and minimum humidity of 33% on 2 October 2026; gusts of 28 km/h on 3 October 2026.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.
Area with fire
≈ 210ha
rebuilt from hotspots, no official perimeter yet
Duration
2days
2 Oct 2026 – 3 Oct 2026
Municipalities hit
3
communes
Started on
2 Oct
2026
Heat detections
15
in a single hotspot: 45 MW
Danger at start
37
High · FWI index
Average daily power
96MW
detected power per day, on average
Where it burned
HOTSPOTS BY DAY
2 Oct3 Oct
Play back3 Oct 2026
How it evolved, day by day
2 Oct3 Oct
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
32°high
28km/h · peak gust
33%lowest humidity
It had gone 10 days without rain (1 mm or more) when it started.
What happened to each town
El M'Ghairالمغير49,793 inhabitants · 9.6 km from the centrewhere it started
168 hareached on 2 Oct
0.1 %
M'Naguerالمنقر14,179 inhabitants · 90.1 km from the centre
28 hareached on 3 Oct
0.0 %
Sidi Khellilسيدي خليل6,547 inhabitants · 8.6 km from the centre
14 hareached on 3 Oct
0.0 %
Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
2 Oct
32.5 °C
33 %
25 km/h
0.0 mm
High 37
3 Oct
31.0 °C
34 %
28 km/h
0.0 mm
High 35
4 Oct after
30.6 °C
30 %
20 km/h
0.0 mm
High 34
5 Oct after
32.1 °C
27 %
17 km/h
0.0 mm
High 26
6 Oct after
34.4 °C
22 %
24 km/h
0.0 mm
Very high 40
7 Oct after
33.9 °C
20 %
24 km/h
0.0 mm
Very high 48
8 Oct after
33.6 °C
16 %
21 km/h
0.0 mm
Very high 42
9 Oct after
33.4 °C
16 %
21 km/h
0.0 mm
Extreme 54
10 Oct after
30.7 °C
23 %
27 km/h
0.0 mm
Very high 45
11 Oct after
29.2 °C
33 %
29 km/h
0.3 mm
Very high 42
12 Oct after
28.4 °C
42 %
20 km/h
0.5 mm
Moderate 19
13 Oct after
30.8 °C
31 %
33 km/h
0.0 mm
Very high 44
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
↔
Before · 25 Sept 2026
After · 10 Oct 2026
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 2 October 2026 the air beside the fire reached 21 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).
PM2.5 peak21µg/m³
Days over the guideline0days
PM1030µg/m³
Optical depth0.31
WHO 15
3012
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 15Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and time
Satellite
FRP (MW)
Lat
Lon
Frequently asked questions
How long did the El M'Ghair fire last?
According to the heat detections seen by satellite, it burned from 2 October 2026 to 3 October 2026 (2 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 210 hectares with fire (2.1 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire entered 3 municipalities: El M'Ghair (168 ha, 0.1 %); M'Naguer (28 ha, 0.0 %); Sidi Khellil (14 ha, 0.0 %).
Did the fire reach a town?
The fire came within 8.6 km of the centre of Sidi Khellil, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 32.5 °C, humidity dropped to 33 % and gusts hit 28 km/h. The fire danger index (FWI) reached 37, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
No perimeter yet: the area (≈ 210 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
Dates of the first and last VIIRS detection of the cluster. 15 Suomi-NPP VIIRS detections on those dates.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.