Skip to content
worldfires
TR · Türkiye · →

Efeler fire, June 2025 İncirliova · Efeler

Out · last detection 22 Jun 2025, 01:04 UTC

The fire started on 21 June 2025 in Efeler, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 366 hectares from satellite imagery, spread across a single municipality.

It is the 5th largest in Aydın since 2016 (of 15 with a page). Number 64 in Türkiye in 2025, of 184.

The power measured by the satellite is low (1.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
366ha
Copernicus perimeter
Duration
2days
21 Jun 2025 – 22 Jun 2025
Municipalities hit
1
districts
Started on
21 Jun
2025
Heat detections
2
in a single hotspot: 2 MW
Danger at start
45
Very high · FWI index
Energy released
3MW
sum of detected power

Where it burned

22 Jun 2025
HOTSPOTS BY DAY 21 Jun22 Jun

How it evolved, day by day

2122

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
46km/h · peak gust
18%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Efeler İncirliova 51,526 inhabitants · 18.6 km from the town where it started
    366 ha reached on 21 Jun
    0.6 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub65 %
  • Scrub and transitional woodland18 %
  • Other natural land17 %
  • Artificial surfaces0.5 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Jun 36.0 °C 26 % 46 km/h 0.3 mm Very high 45
22 Jun 34.8 °C 18 % 42 km/h 0.0 mm Very high 48
23 Jun after 36.6 °C 7 % 33 km/h 0.0 mm Extreme 50
24 Jun after 38.0 °C 12 % 29 km/h 0.0 mm Extreme 53
25 Jun after 39.9 °C 8 % 27 km/h 0.0 mm Extreme 52
26 Jun after 41.4 °C 8 % 27 km/h 0.0 mm Extreme 54
27 Jun after 41.6 °C 10 % 31 km/h 0.0 mm Extreme 53
28 Jun after 40.1 °C 13 % 45 km/h 0.0 mm Extreme 64
29 Jun after 35.8 °C 21 % 56 km/h 0.0 mm Extreme 58
30 Jun after 36.5 °C 15 % 45 km/h 0.0 mm Extreme 51
1 Jul after 37.9 °C 17 % 32 km/h 0.0 mm Very high 50
2 Jul after 38.0 °C 12 % 42 km/h 0.0 mm Extreme 55

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 14 Jun 2025
After · 29 Jun 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 June 2025 the air beside the fire reached 12 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak12 µg/m³
Days over the guideline0 days
PM1016 µg/m³
Optical depth0.33
19202122232425
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Efeler fire last?
Copernicus dates it between 21 June 2025 and 22 June 2025: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 366 hectares (3.7 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Efeler (366 ha, 0.6 %).
Did the fire reach a town?
The closest fire to a town centre came within 18.6 km of Efeler. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 36.0 °C, humidity dropped to 18 % and gusts hit 46 km/h. The fire danger index (FWI) reached 48, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.