Skip to content
worldfires
UA · Ukraine · →

Dobropillia fire, July 2026 Добропільський район · Ukraine

Out · last detection 22 Sept 2026, 11:30 UTC

Satellites first detected fire on 31 July 2026 in Dobropillia, Ukraine. It was active for 54 days, with 89 heat detections and an area with fire of about 168 hectares rebuilt from them, spread across a single municipality.

Compare with…

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 168ha
rebuilt from hotspots, no official perimeter yet
Duration
54days
31 Jul 2026 – 22 Sept 2026
Municipalities hit
0
districts
Started on
31 Jul
2026
Heat detections
89
in a single hotspot: 74 MW
Danger at start
16
Moderate · FWI index
Average daily power
13MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 31 Jul22 Sept
22 Sept 2026

How it evolved, day by day

1 Aug 2026 · 9 MW · 5 6 Aug 2026 · 12 MW · 3 7 Aug 2026 · 24 MW · 4 10 Aug 2026 · 2 MW · 2 11 Aug 2026 · 1 MW · 1 13 Aug 2026 · 2 MW · 1 14 Aug 2026 · 3 MW · 1 15 Aug 2026 · 5 MW · 1 16 Aug 2026 · 5 MW · 1 17 Aug 2026 · 35 MW · 6 18 Aug 2026 · 43 MW · 9 19 Aug 2026 · 1 MW · 1 20 Aug 2026 · 1 MW · 1 21 Aug 2026 · 8 MW · 3 22 Aug 2026 · 30 MW · 5 23 Aug 2026 · 61 MW · 5 24 Aug 2026 · 79 MW · 2 26 Aug 2026 · 1 MW · 2 2 Sept 2026 · 0 MW · 1 3 Sept 2026 · 9 MW · 1 8 Sept 2026 · 10 MW · 5 9 Sept 2026 · 8 MW · 3 10 Sept 2026 · 8 MW · 2 11 Sept 2026 · 1 MW · 2 12 Sept 2026 · 1 MW · 2 13 Sept 2026 · 13 MW · 3 17 Sept 2026 · 2 MW · 1 19 Sept 2026 · 0 MW · 0 20 Sept 2026 · 0 MW · 0 21 Sept 2026 · 1 MW · 1 22 Sept 2026 · 3 MW · 1
1 Aug 13 Aug 18 Aug 23 Aug 24 Aug 8 Sept 13 Sept 22 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
35km/h · peak gust
32%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started. Rain came after the fire: 25.5 mm on 23 Sept.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
19 Sept 25.2 °C 32 % 17 km/h 0.0 mm Moderate 16
20 Sept 26.8 °C 32 % 14 km/h 0.0 mm Moderate 17
21 Sept 26.0 °C 32 % 30 km/h 0.3 mm High 23
22 Sept 21.5 °C 49 % 35 km/h 2.7 mm Very low 5
23 Sept after 18.4 °C 79 % 61 km/h 25.5 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Jul 2026
After · 29 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 September 2026 the air beside the fire reached 28 µg/m³ of PM2.5. That day averaged 16: 1.0 times the WHO daily guideline (15).

PM2.5 peak28 µg/m³
Days over the guideline1 day
PM1041 µg/m³
Optical depth0.42
171819202122232425
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 89Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Dobropillia fire last?
According to the heat detections seen by satellite, it burned from 31 July 2026 to 22 September 2026 (54 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 168 hectares with fire (1.7 km²); Copernicus will publish the measured figure within days.
What was the weather like?
During the fire the temperature reached 26.8 °C, humidity dropped to 32 % and gusts hit 35 km/h. The fire danger index (FWI) reached 23, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • No perimeter yet: the area (≈ 168 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 89 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.