Skip to content
worldfires
EL · Greece · →

Dionysos fire, July 2024 Διόνυσος · Dionysos

Out · last detection 1 Jul 2024, 00:37 UTC

The fire started on 1 July 2024 in Dionysos, Greece, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 139 hectares from satellite imagery, spread across a single municipality.

It is the 27th largest in Attica since 2016 (of 32 with a page). Number 34 in Greece in 2024, of 42.

The power measured by the satellite is low (1.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
139ha
Copernicus perimeter
Duration
1day
1 Jul 2024 – 1 Jul 2024
Municipalities hit
1
municipalities
Started on
1 Jul
2024
Heat detections
1
in a single hotspot: 1 MW
Danger at start
32
High · FWI index
Average daily power
1MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 1 Jul1 Jul

How it evolved, day by day

1 Jul 2024 · 1 MW · 1

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
37km/h · peak gust
36%lowest humidity

It had gone 47 days without rain (1 mm or more) when it started. Rain came after the fire: 15.0 mm on 4 Jul.

This area had burned before

4% of the perimeter overlaps earlier fires recorded since 2016: 5 ha in 2021.

What happened to each town

  1. Dionysos Διόνυσος where it started
    139 ha reached on 1 Jul
    2.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland57 %
  • Agricultural areas25 %
  • Sclerophyllous scrub17 %
  • Artificial surfaces1.4 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Jul 30.1 °C 36 % 37 km/h 0.0 mm High 32
2 Jul after 33.1 °C 28 % 38 km/h 0.0 mm High 34
3 Jul after 27.7 °C 39 % 35 km/h 0.8 mm High 25
4 Jul after 25.8 °C 60 % 30 km/h 15.0 mm Very low 1

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Jun 2024
After · 8 Jul 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 3 July 2024 the air beside the fire reached 22 µg/m³ of PM2.5. That day averaged 15: 1.0 times the WHO daily guideline (15).

PM2.5 peak22 µg/m³
Days over the guideline1 day
PM1056 µg/m³
Optical depth0.62
29301234
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Greece ›

Frequently asked questions

How long did the Dionysos fire last?
Copernicus dates it between 1 July 2024 and 1 July 2024: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 139 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Dionysos (139 ha, 2.2 %).
What was the weather like?
During the fire the temperature reached 30.1 °C, humidity dropped to 36 % and gusts hit 37 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Greece (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 199 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 199.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. One Suomi-NPP VIIRS detection on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.