Skip to content
worldfires
SD · Sudan · →

Dilling fire, 18 October 2026 Dilling, Ar Reif Ash Shargi

Out · last detection 21 Oct 2026, 23:09 UTC

The fire started on 18 October 2026 in Dilling, Sudan, and satellites saw it burning for 7 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,286 hectares from heat detections, spread across 2 municipalities.

It is the 340th largest in South Kordofan since 2016 (of 442 with a page). Number 181 in Sudan in 2026, of 235.

The power measured by the satellite is low (24.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
2,286ha
GWIS perimeter (Copernicus)
Duration
7days
18 Oct 2026 – 24 Oct 2026
Municipalities hit
2
localities
Started on
18 Oct
2026
Heat detections
47
in a single hotspot: 24 MW
Danger at start
57
Extreme · FWI index
Average daily power
101MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Oct24 Oct
21 Oct 2026

How it evolved, day by day

19 Oct 2026 · 116 MW · 25 20 Oct 2026 · 184 MW · 20 21 Oct 2026 · 3 MW · 2
19 Oct 20 Oct 21 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
46km/h · peak gust
12%lowest humidity

It had gone 17 days without rain (1 mm or more) when it started.

This area had burned before

39% of the perimeter overlaps earlier fires recorded since 2016: 654 ha in 2020, 231 ha in 2025.

How big is it?

10 km
It burned the equivalent of 1.4% of the area of London (23 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Dilling where it started
    2,285 ha reached on 19 Oct
    0.6 %
  2. 11 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Oct 38.4 °C 13 % 36 km/h 0.0 mm Extreme 57
19 Oct 38.9 °C 15 % 41 km/h 0.0 mm Extreme 60
20 Oct 39.6 °C 16 % 37 km/h 0.0 mm Extreme 57
21 Oct 39.6 °C 15 % 38 km/h 0.0 mm Extreme 64
22 Oct 39.7 °C 13 % 46 km/h 0.0 mm Very extreme 74
23 Oct 39.2 °C 14 % 44 km/h 0.0 mm Very extreme 74
24 Oct 39.1 °C 12 % 39 km/h 0.0 mm Extreme 68
25 Oct after 38.9 °C 11 % 44 km/h 0.0 mm Very extreme 71

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Oct 2026
After · 24 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 16 October 2026 the air beside the fire reached 58 µg/m³ of PM2.5. That day averaged 42: 2.8 times the WHO daily guideline (15).

PM2.5 peak58 µg/m³
Days over the guideline5 days
PM10210 µg/m³
Optical depth0.52
1617181920
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 47Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Sudan ›

Frequently asked questions

How long did the Dilling fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 18 October 2026 to 24 October 2026 (7 days). The perimeter dates it from 19 October 2026 to 21 October 2026.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,286 hectares (22.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Dilling (2,285 ha, 0.6 %); Ar Reif Ash Shargi (11 ha, 0.0 %).
Is the Dilling fire still active?
No fire detections since 21 Oct 2026, 23:09 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 39.7 °C, humidity dropped to 12 % and gusts hit 46 km/h. The fire danger index (FWI) reached 74, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Sudan (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 19 October 2026 to 21 October 2026. 47 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.