How long did the Delami fire last?

According to the heat detections seen by satellite inside the perimeter, it burned from 13 October 2026 to 22 October 2026 (10 days). The perimeter dates it from 16 October 2026 to 22 October 2026.

How much area did it burn?

The perimeter GWIS (Copernicus) rebuilt from heat detections is 8,918 hectares (89.2 km²). It is an estimate: official national figures may differ.

Which municipalities burned?

The fire only entered Delami (8,976 ha, 2.2 %).

Is the Delami fire still active?

No fire detections since 22 Oct 2026, 11:57 UTC. A lack of detections is not an official extinction.

What was the weather like?

During the fire the temperature reached 38.8 °C, humidity dropped to 13 % and gusts hit 40 km/h. The fire danger index (FWI) reached 54, class Extreme.

Where does this data come from?

From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Sudan (geoBoundaries). It is not an official report.

SD · Sudan · 2026-10-13 → 2026-10-22

Delami fire, 13 October 2026 Delami

Dying down · last detection 22 Oct 2026, 11:57 UTC

The fire started on 13 October 2026 in Delami, Sudan, and satellites saw it burning for 10 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 8,918 hectares from heat detections, spread across a single municipality.

It is the 18th largest in South Kordofan since 2016 (of 440 with a page). Number 7 in Sudan in 2026, of 215.

The power measured by the satellite is low (20.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Is it still active?

No detections since 22 Oct 2026, 11:57 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Burnt area: 8,918ha; GWIS perimeter (Copernicus)
Duration: 10days; 13 Oct 2026 – 22 Oct 2026
Municipalities hit: 1; localities
Started on: 13 Oct; 2026
Heat detections: 134; in a single hotspot: 20 MW
Danger at start: 36; High · FWI index
Energy released: 874MW; sum of detected power

Play back 22 Oct 2026

HOTSPOTS BY DAY 13 Oct22 Oct

How it evolved, day by day

13141516171819202122

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

39°high

40km/h · peak gust

13%lowest humidity

It had gone 11 days without rain (1 mm or more) when it started.

This area had burned before

11% of the perimeter overlaps earlier fires recorded since 2016: 15 ha in 2016, 252 ha in 2022, 246 ha in 2024, 522 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 939 ha that had burned before.

What happened to each town

Delami where it started

8,976 ha reached on 13 Oct

2.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day	High	Min. humidity	Peak gust	Rain	Danger (FWI)
13 Oct	36.2 °C	27 %	35 km/h	0.2 mm	High 36
14 Oct	37.6 °C	24 %	26 km/h	0.0 mm	High 37
15 Oct	38.8 °C	18 %	29 km/h	0.0 mm	Very high 39
16 Oct	38.6 °C	15 %	38 km/h	0.0 mm	Extreme 51
17 Oct	37.7 °C	14 %	33 km/h	0.0 mm	Very high 47
18 Oct	37.8 °C	13 %	36 km/h	0.0 mm	Extreme 51
19 Oct	38.3 °C	15 %	40 km/h	0.0 mm	Extreme 54

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

↔

Before · 6 Oct 2026

After · 23 Oct 2026

Before After

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 16 October 2026 the air beside the fire reached 64 µg/m³ of PM2.5. That day averaged 44: 3.0 times the WHO daily guideline (15).

PM2.5 peak64 µg/m³

Days over the guideline6 days

PM10232 µg/m³

Optical depth0.52

WHO 15

1112131415161718

Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 134Every satellite heat detection, one by one, with time, satellite, power and coordinates.

⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.

Date and time	Satellite	FRP (MW)	Lat	Lon

Other fires nearby

All fires in Sudan ›

Frequently asked questions

How long did the Delami fire last?: According to the heat detections seen by satellite inside the perimeter, it burned from 13 October 2026 to 22 October 2026 (10 days). The perimeter dates it from 16 October 2026 to 22 October 2026.
How much area did it burn?: The perimeter GWIS (Copernicus) rebuilt from heat detections is 8,918 hectares (89.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?: The fire only entered Delami (8,976 ha, 2.2 %).
Is the Delami fire still active?: No fire detections since 22 Oct 2026, 11:57 UTC. A lack of detections is not an official extinction.
What was the weather like?: During the fire the temperature reached 38.8 °C, humidity dropped to 13 % and gusts hit 40 km/h. The fire danger index (FWI) reached 54, class Extreme.
Where does this data come from?: From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Sudan (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

NASA FIRMS ↗
GWIS · Copernicus ↗

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error

What do you think is wrong?

Dates or duration Place or towns Burned area Name It was not a wildfire Same fire as another page Something else

What really happened?

Your connection to the fire (optional) Email (optional)

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.