Skip to content
worldfires
GE · Georgia · →

Dedoplis Tskaro fire, 18 August 2026 Dedoplis Tskaro

Out · last detection 18 Aug 2026, 10:41 UTC

The fire started on 18 August 2026 in Dedoplis Tskaro, Georgia, and satellites saw it burning for 1 day. Copernicus’s global GWIS system rebuilt a burnt perimeter of 350 hectares from heat detections, spread across a single municipality.

It is the 143th largest in Kakheti since 2016 (of 201 with a page). Number 26 in Georgia in 2026, of 37.

The power measured by the satellite is low (5.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
350ha
GWIS perimeter (Copernicus)
Duration
1day
18 Aug 2026 – 18 Aug 2026
Municipalities hit
1
municipalities
Started on
18 Aug
2026
Heat detections
4
in a single hotspot: 5 MW
Danger at start
5
Very low · FWI index
Energy released
18MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 18 Aug18 Aug

How it evolved, day by day

18

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
27km/h · peak gust
40%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 7.5 mm on 20 Aug.

This area had burned before

99% of the perimeter overlaps earlier fires recorded since 2016: 257 ha in 2016, 2 ha in 2017, 157 ha in 2019, 41 ha in 2020, 70 ha in 2021, 52 ha in 2022, 46 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 348 ha that had burned before.

What happened to each town

  1. Dedoplis Tskaro where it started
    350 ha reached on 18 Aug
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Aug 31.3 °C 40 % 27 km/h 1.1 mm Very low 5
19 Aug after 31.8 °C 37 % 21 km/h 0.0 mm Moderate 11
20 Aug after 29.7 °C 53 % 21 km/h 7.5 mm Very low 1

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Aug 2026
After · 25 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 17 August 2026 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline4 days
PM1086 µg/m³
Optical depth0.42
161718192021
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 4Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Georgia ›

Frequently asked questions

How long did the Dedoplis Tskaro fire last?
GWIS (Copernicus) dates it between 18 August 2026 and 18 August 2026: 1 day between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 350 hectares (3.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Dedoplis Tskaro (350 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 31.3 °C, humidity dropped to 40 % and gusts hit 27 km/h. The fire danger index (FWI) reached 5, class Very low.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Georgia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.