Skip to content
worldfires
GE · Georgia · →

Dedoplis Tskaro fire, 8 August 2026 Dedoplis Tskaro

Out · last detection 8 Aug 2026, 22:48 UTC

The fire started on 8 August 2026 in Dedoplis Tskaro, Georgia, and satellites saw it burning for 2 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 300 hectares from heat detections, spread across a single municipality.

It is the 207th largest in Kakheti since 2016 (of 208 with a page). Number 40 in Georgia in 2026, of 40.

The power measured by the satellite is low (4.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
300ha
GWIS perimeter (Copernicus)
Duration
2days
8 Aug 2026 – 9 Aug 2026
Municipalities hit
1
municipalities
Started on
8 Aug
2026
Heat detections
5
in a single hotspot: 5 MW
Danger at start
35
High · FWI index
Average daily power
14MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 8 Aug9 Aug

How it evolved, day by day

8 Aug 2026 · 14 MW · 5

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

35°high
55km/h · peak gust
23%lowest humidity

It had gone 18 days without rain (1 mm or more) when it started. Rain came after the fire: 8.8 mm on 14 Aug.

This area had burned before

56% of the perimeter overlaps earlier fires recorded since 2016: 1 ha in 2017, 39 ha in 2018, 136 ha in 2025.

What happened to each town

  1. Dedoplis Tskaro where it started
    300 ha
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Aug 34.3 °C 26 % 55 km/h 0.0 mm High 35
9 Aug 34.8 °C 23 % 48 km/h 0.0 mm High 34
10 Aug after 32.5 °C 26 % 44 km/h 0.4 mm High 36
11 Aug after 30.5 °C 47 % 26 km/h 0.1 mm High 24
12 Aug after 31.5 °C 39 % 29 km/h 0.1 mm High 25
13 Aug after 32.8 °C 34 % 31 km/h 0.6 mm High 25
14 Aug after 29.4 °C 38 % 28 km/h 8.8 mm Very low 5

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Aug 2026
After · 16 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 8 August 2026 the air beside the fire reached 31 µg/m³ of PM2.5. That day averaged 22: 1.5 times the WHO daily guideline (15).

PM2.5 peak31 µg/m³
Days over the guideline6 days
PM1069 µg/m³
Optical depth0.63
6789101112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Georgia ›

Frequently asked questions

How long did the Dedoplis Tskaro fire last?
GWIS (Copernicus) dates it between 8 August 2026 and 9 August 2026: 2 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 300 hectares (3.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Dedoplis Tskaro (300 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 34.8 °C, humidity dropped to 23 % and gusts hit 55 km/h. The fire danger index (FWI) reached 35, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Georgia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.