Skip to content
worldfires
GE · Georgia · →

Dedoplis Tskaro fire, 3 September 2024 Dedoplis Tskaro

Out · last detection 4 Sept 2024, 09:59 UTC

The fire started on 3 September 2024 in Dedoplis Tskaro, Georgia, and satellites saw it burning for 2 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 353 hectares from heat detections, spread across a single municipality.

It is the 146th largest in Kakheti since 2016 (of 208 with a page). Number 15 in Georgia in 2024, of 22.

The power measured by the satellite is low (17.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
353ha
GWIS perimeter (Copernicus)
Duration
2days
3 Sept 2024 – 4 Sept 2024
Municipalities hit
1
municipalities
Started on
3 Sept
2024
Heat detections
9
in a single hotspot: 17 MW
Danger at start
24
High · FWI index
Average daily power
30MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Sept4 Sept
4 Sept 2024

How it evolved, day by day

3 Sept 2024 · 16 MW · 3 4 Sept 2024 · 46 MW · 6
3 Sept 4 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
22km/h · peak gust
25%lowest humidity

It had gone 7 days without rain (1 mm or more) when it started.

This area had burned before

94% of the perimeter overlaps earlier fires recorded since 2016: 55 ha in 2016, 160 ha in 2017, 277 ha in 2018, 228 ha in 2019, 43 ha in 2021. Part of it burned more than once, so the yearly figures add up to more than the 331 ha that had burned before.

What happened to each town

  1. Dedoplis Tskaro where it started
    353 ha reached on 3 Sept
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Sept 31.3 °C 33 % 21 km/h 0.0 mm High 24
4 Sept 30.6 °C 25 % 22 km/h 0.0 mm High 25
5 Sept after 30.4 °C 30 % 27 km/h 0.0 mm High 27
6 Sept after 25.5 °C 28 % 47 km/h 0.1 mm High 31
7 Sept after 25.2 °C 33 % 34 km/h 0.0 mm High 27
8 Sept after 26.5 °C 30 % 26 km/h 0.0 mm High 24
9 Sept after 28.6 °C 32 % 21 km/h 0.0 mm High 24
10 Sept after 25.6 °C 52 % 17 km/h 0.0 mm Moderate 17
11 Sept after 31.8 °C 36 % 19 km/h 0.0 mm High 22
12 Sept after 30.5 °C 43 % 25 km/h 0.1 mm High 23
13 Sept after 29.0 °C 23 % 33 km/h 0.2 mm High 32
14 Sept after 26.3 °C 28 % 33 km/h 0.1 mm High 32

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Aug 2024
After · 11 Sept 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 7 September 2024 the air beside the fire reached 29 µg/m³ of PM2.5. That day averaged 20: 1.3 times the WHO daily guideline (15).

PM2.5 peak29 µg/m³
Days over the guideline5 days
PM10168 µg/m³
Optical depth0.68
1234567
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Georgia ›

Frequently asked questions

How long did the Dedoplis Tskaro fire last?
GWIS (Copernicus) dates it between 3 September 2024 and 4 September 2024: 2 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 353 hectares (3.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Dedoplis Tskaro (353 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 31.3 °C, humidity dropped to 25 % and gusts hit 22 km/h. The fire danger index (FWI) reached 25, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Georgia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.