Skip to content
worldfires
DZ · Algeria · →

Darguina fire, 14 October 2023 درقينة · Melbou, Souk El Tenine, Darguina

Out · last detection 18 Oct 2023, 12:18 UTC

The fire started on 14 October 2023 in Darguina, Algeria, and satellites saw it burning for 5 days. Copernicus mapped a burnt perimeter of 284 hectares from satellite imagery, spread across 4 municipalities.

It is the 35th largest in Jijel since 2016 (of 110 with a page). Number 35 in Algeria in 2023, of 86.

The power measured by the satellite is low (14.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
284ha
Copernicus perimeter
Duration
5days
14 Oct 2023 – 18 Oct 2023
Municipalities hit
4
communes
Started on
14 Oct
2023
Heat detections
15
in a single hotspot: 14 MW
Danger at start
39
Very high · FWI index
Average daily power
52MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Oct18 Oct
18 Oct 2023

How it evolved, day by day

17 Oct 2023 · 7 MW · 1 18 Oct 2023 · 95 MW · 14
17 Oct 18 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
40km/h · peak gust
19%lowest humidity

It had gone 23 days without rain (1 mm or more) when it started. Rain came after the fire: 4.4 mm on 24 Oct.

This area had burned before

25% of the perimeter overlaps earlier fires recorded since 2016: 69 ha in 2020, 1 ha in 2021, 2 ha in 2022.

What happened to each town

  1. Melbou ملبو 11,396 inhabitants · 4.0 km from the centre
    190 ha reached on 18 Oct
    4.0 %
  2. Souk El Tenine سوق الإثنين،بجاية 14,045 inhabitants · 2.3 km from the centre
    64 ha reached on 18 Oct
    2.4 %
  3. Darguina درقينة 14,146 inhabitants · 4.3 km from the centre where it started
    29 ha reached on 17 Oct
    0.3 %
  4. Tamridjet تامريجت 8,413 inhabitants · 1.6 km from the centre
    1 ha reached on 18 Oct
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest71 %
  • Other natural land29 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2025
Built-up area2.1 ha
Residents≈ 300

Inside the perimeter there were about 2.1 hectares of built-up land and about 300 residents (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Oct 33.3 °C 19 % 38 km/h 0.0 mm Very high 39
18 Oct 32.3 °C 29 % 40 km/h 0.0 mm Very high 40
19 Oct after 30.1 °C 26 % 53 km/h 0.0 mm Very high 44
20 Oct after 29.9 °C 25 % 54 km/h 0.0 mm Extreme 50
21 Oct after 24.1 °C 42 % 32 km/h 0.0 mm High 28
22 Oct after 29.0 °C 23 % 37 km/h 0.0 mm High 33
23 Oct after 30.8 °C 28 % 41 km/h 0.0 mm High 38
24 Oct after 26.0 °C 41 % 37 km/h 4.4 mm Low 7

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Oct 2023
After · 25 Oct 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 20 October 2023 the air beside the fire reached 42 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak42 µg/m³
Days over the guideline2 days
PM10151 µg/m³
Optical depth0.63
15161718192021
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 15Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Darguina fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 14 October 2023 to 18 October 2023 (5 days). The perimeter dates it from 17 October 2023 to 18 October 2023.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 284 hectares (2.8 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 4 municipalities: Melbou (190 ha, 4.0 %); Souk El Tenine (64 ha, 2.4 %); Darguina (29 ha, 0.3 %); Tamridjet (1 ha, 0.0 %).
Did the fire reach a town?
The fire came within 1.6 km of the centre of Tamridjet, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 33.3 °C, humidity dropped to 19 % and gusts hit 40 km/h. The fire danger index (FWI) reached 40, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings ›

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 17 October 2023 → 14 October 2023.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 17 October 2023 to 18 October 2023. 15 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.