Danlí fire, 19 May 2024 Danlí
The fire started on 19 May 2024 in Danlí, Honduras, and satellites saw it burning for 8 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,425 hectares from heat detections, spread across a single municipality.
It is the 39th largest in El Paraíso since 2016 (of 63 with a page). Number 41 in Honduras in 2024, of 94.
The power measured by the satellite is low (8.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
- Burnt area
- 1,425ha
- GWIS perimeter (Copernicus)
- Duration
- 8days
- 19 May 2024 – 26 May 2024
- Municipalities hit
- 1
- municipalities
- Started on
- 19 May
- 2024
- Heat detections
- 44
- in a single hotspot: 9 MW
- Danger at start
- 31
- High · FWI index
- Energy released
- 114MW
- sum of detected power
Where it burned
How it evolved, day by day
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 4.6 mm on 27 May.
This area had burned before
100% of the perimeter overlaps earlier fires recorded since 2016: 1,312 ha in 2016, 985 ha in 2020. Part of it burned more than once, so the yearly figures add up to more than the 1,431 ha that had burned before.
What happened to each town
-
Danlí where it started1,434 ha reached on 19 May0.6 %
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 19 May | 33.9 °C | 34 % | 36 km/h | 0.0 mm | High 31 |
| 20 May | 35.0 °C | 28 % | 34 km/h | 0.0 mm | High 33 |
| 21 May | 35.9 °C | 27 % | 35 km/h | 0.2 mm | High 34 |
| 22 May | 34.7 °C | 31 % | 22 km/h | 0.2 mm | High 30 |
| 23 May | 31.3 °C | 49 % | 24 km/h | 2.3 mm | Low 8 |
| 24 May | 33.7 °C | 38 % | 27 km/h | 0.7 mm | Moderate 20 |
| 25 May | 33.6 °C | 38 % | 27 km/h | 1.3 mm | Moderate 18 |
| 26 May | 36.9 °C | 23 % | 28 km/h | 0.3 mm | High 32 |
| 27 May after | 34.2 °C | 38 % | 34 km/h | 4.6 mm | Low 9 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · CopernicusOn 23 May 2024 the air beside the fire reached 71 µg/m³ of PM2.5. That day averaged 30: 2.0 times the WHO daily guideline (15).
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table · 44Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
- 5,379 haDanlí6 April 2016 · 16 days · 17 km away
- 5,314 haDanlí16 April 2020 · 19 days · 22 km away
- 4,819 haTeupasenti7 April 2020 · 15 days · 26 km away
- 6,300 haDanlí16 March 2019 · 15 days · 33 km away
- 4,994 haTeupasenti4 April 2020 · 24 days · 33 km away
- 7,373 haDanlí16 April 2022 · 7 days · 36 km away
Frequently asked questions
- How long did the Danlí fire last?
- GWIS (Copernicus) dates it between 19 May 2024 and 26 May 2024: 8 days between the first and last heat detection of the perimeter.
- How much area did it burn?
- The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,425 hectares (14.2 km²). It is an estimate: official national figures may differ.
- Which municipalities burned?
- The fire only entered Danlí (1,434 ha, 0.6 %).
- What was the weather like?
- During the fire the temperature reached 36.9 °C, humidity dropped to 23 % and gusts hit 36 km/h. The fire danger index (FWI) reached 34, class High.
- Where does this data come from?
- From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Honduras (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 911
Satellite cross-check
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
Where this data comes from
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.