Skip to content
worldfires
TD · Chad · →

Dababa fire, 7 November 2025 Dababa

Out · last detection 10 Nov 2025, 11:37 UTC

The fire started on 7 November 2025 in Dababa, Chad, and satellites saw it burning for 4 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 6,771 hectares from heat detections, spread across a single municipality.

It is the 2th largest in Hadjer-Lamis since 2016 (of 13 with a page). Number 32 in Chad in 2025, of 274.

The power measured by the satellite is low (28.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
6,771ha
GWIS perimeter (Copernicus)
Duration
4days
7 Nov 2025 – 10 Nov 2025
Municipalities hit
1
departments
Started on
7 Nov
2025
Heat detections
97
in a single hotspot: 29 MW
Danger at start
53
Extreme · FWI index
Energy released
678MW
sum of detected power

Where it burned

10 Nov 2025
HOTSPOTS BY DAY 7 Nov10 Nov

How it evolved, day by day

78910

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
35km/h · peak gust
11%lowest humidity

It had gone 42 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Dababa where it started
    6,826 ha reached on 7 Nov
    0.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
7 Nov 39.0 °C 12 % 27 km/h 0.0 mm Extreme 53
8 Nov 39.5 °C 12 % 25 km/h 0.0 mm Extreme 53
9 Nov 39.4 °C 14 % 35 km/h 0.0 mm Extreme 60
10 Nov 38.6 °C 11 % 32 km/h 0.0 mm Extreme 62
11 Nov after 37.0 °C 8 % 33 km/h 0.0 mm Extreme 59
12 Nov after 38.6 °C 10 % 30 km/h 0.0 mm Extreme 58
13 Nov after 39.2 °C 14 % 34 km/h 0.0 mm Extreme 63
14 Nov after 37.9 °C 14 % 39 km/h 0.0 mm Extreme 63
15 Nov after 35.2 °C 11 % 37 km/h 0.0 mm Extreme 63
16 Nov after 34.3 °C 12 % 36 km/h 0.0 mm Extreme 60
17 Nov after 36.0 °C 12 % 31 km/h 0.0 mm Extreme 57
18 Nov after 37.5 °C 12 % 30 km/h 0.0 mm Extreme 59
19 Nov after 38.2 °C 11 % 31 km/h 0.0 mm Extreme 58
20 Nov after 38.2 °C 11 % 32 km/h 0.0 mm Extreme 56

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 31 Oct 2025
After · 17 Nov 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 7 November 2025 the air beside the fire reached 56 µg/m³ of PM2.5. That day averaged 27: 1.8 times the WHO daily guideline (15).

PM2.5 peak56 µg/m³
Days over the guideline6 days
PM10130 µg/m³
Optical depth0.44
5678910111213
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 97Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Chad ›

Frequently asked questions

How long did the Dababa fire last?
GWIS (Copernicus) dates it between 7 November 2025 and 10 November 2025: 4 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 6,771 hectares (67.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Dababa (6,826 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 39.5 °C, humidity dropped to 11 % and gusts hit 35 km/h. The fire danger index (FWI) reached 62, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Chad (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.