Skip to content
worldfires
US · United States · –

Coos fire, 16 November 2026 Coos

Dying down · last detection 20 Nov 2026, 21:52 UTC

Satellites first detected fire on 16 November 2026 in Coos, United States. It has been active for 5 days, with 49 heat detections and an area with fire of about 448 hectares rebuilt from them, spread across a single county.

Compare with…

NIFC has not yet published the perimeter of this fire. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

No detections since 20 Nov 2026, 21:52 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Area with fire
≈ 448ha
rebuilt from hotspots, no official perimeter yet
Duration
5days
16 Nov 2026 – 20 Nov 2026
Counties hit
1
counties
Started on
16 Nov
2026
Heat detections
49
in a single hotspot: 66 MW
Danger at start
0
Very low · FWI index
Average daily power
195MW
detected power per day, on average

The next 72 hours

The wind is blowing from the south-east and pushing to the north-west; no sharp shifts are expected until Tue 24, 01:00.

ECMWF IFS 0.25° at the centre of the fire · computed 21 Nov 2026, 09:23 UTC

Sat 21, 03:00, local time

First useful rain: 2.0 mm in 6 h

Chance of rain up to 77 % in those hours. It can slow the fire at the surface, but that does not mean it will go out.

Checked, no warning: no wind shifts of more than 60° nights recover humidity (peaks of 75 % or more)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/United States Census Bureau, MAF/TIGER Database (Public Domain)

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Emergencies · United States 911 Emergency number and official warnings

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: VIIRS (NASA FIRMS); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/United States Census Bureau, MAF/TIGER Database (Public Domain).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 16 Nov20 Nov
    20 Nov 2026

    How it evolved, day by day

    16 Nov 2026 · 0 MW · 0 17 Nov 2026 · 241 MW · 11 19 Nov 2026 · 274 MW · 19 20 Nov 2026 · 71 MW · 18
    16 Nov 17 Nov 19 Nov 20 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    The weather it burned in

    13°high
    50km/h · peak gust
    54%lowest humidity

    It had gone 0 days without rain (1 mm or more) when it started.

    What happened to each county

    1. Coos where it started
      448 ha reached on 16 Nov
      0.1 %

    Area with fire inside each county, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until NIFC publishes the official perimeter. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Day High Min. humidity Peak gust Rain Danger (FWI)
    16 Nov 10.6 °C 89 % 28 km/h 11.7 mm Very low 0
    17 Nov 13.2 °C 54 % 40 km/h 2.0 mm Very low 0
    18 Nov 11.1 °C 66 % 50 km/h 16.4 mm Very low 0
    19 Nov 11.5 °C 60 % 18 km/h 0.7 mm Very low 0
    20 Nov 12.1 °C 56 % 19 km/h 0.0 mm Very low 0

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 9 Nov 2026
    After · 20 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    Detections table · 49Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Frequently asked questions

    How long did the Coos fire last?
    According to the heat detections seen by satellite, it burned from 16 November 2026 to 20 November 2026 (5 days between the first and the last detection). There is no perimeter yet to date it.
    How much area did it burn?
    There is no official perimeter yet: NIFC has not published it. Heat detections rebuild about 448 hectares with fire (4.5 km²).
    Which counties burned?
    The fire only entered Coos (448 ha, 0.1 %).
    Is the Coos fire still active?
    No fire detections since 20 Nov 2026, 21:52 UTC. A lack of detections is not an official extinction.
    What was the weather like?
    During the fire the temperature reached 13.2 °C, humidity dropped to 54 % and gusts hit 50 km/h. The fire danger index (FWI) reached 0, class Very low.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the south-east and pushing to the north-west; no sharp shifts are expected until Tue 24, 01:00. First useful rain: 2.0 mm in 6 h (Sat 21, 03:00). Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 21 Nov 2026, 09:23 UTC; this is not an official warning.
    Where does this data come from?
    From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Emergency number: 911 · Emergency number and official warnings

    Satellite cross-check

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

    How we know this
    • No perimeter yet: the area (≈ 448 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
    • Dates of the first and last VIIRS detection of the cluster. 49 Suomi-NPP VIIRS detections on those dates.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.