Skip to content
worldfires
IT · Italy · →

Condofuri fire, August 2019 Condofuri

Out · last detection 4 Aug 2019, 00:57 UTC

The fire started on 4 August 2019 in Condofuri, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 104 hectares from satellite imagery, spread across a single municipality.

It is the 93th largest in Reggio di Calabria since 2016 (of 101 with a page). Number 96 in Italy in 2019, of 103.

The power measured by the satellite is low (2.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
104ha
Copernicus perimeter
Duration
1day
4 Aug 2019 – 4 Aug 2019
Municipalities hit
1
municipalities
Started on
4 Aug
2019
Heat detections
1
in a single hotspot: 2 MW
Danger at start
23
High · FWI index
Energy released
2MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 4 Aug4 Aug

How it evolved, day by day

4

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
36km/h · peak gust
47%lowest humidity

It had gone 18 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Condofuri 4,604 inhabitants · 0.6 km from the town where it started
    105 ha reached on 4 Aug
    1.8 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas69 %
  • Scrub and transitional woodland16 %
  • Other natural land15 %

Natura 2000 protected area affected: 1 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
4 Aug 27.7 °C 47 % 36 km/h 0.0 mm High 23
5 Aug after 27.8 °C 44 % 28 km/h 0.0 mm Moderate 19
6 Aug after 28.9 °C 39 % 24 km/h 0.0 mm Moderate 20
7 Aug after 28.5 °C 41 % 30 km/h 0.0 mm High 23
8 Aug after 29.1 °C 50 % 33 km/h 0.0 mm High 22
9 Aug after 28.3 °C 60 % 32 km/h 0.0 mm Moderate 19
10 Aug after 29.5 °C 52 % 24 km/h 0.0 mm Moderate 17
11 Aug after 29.5 °C 54 % 29 km/h 0.0 mm Moderate 20
12 Aug after 30.7 °C 45 % 21 km/h 0.0 mm Moderate 19
13 Aug after 30.9 °C 50 % 31 km/h 0.0 mm High 23
14 Aug after 27.3 °C 54 % 54 km/h 0.0 mm High 27

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 28 Jul 2019
After · 11 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 3 August 2019 the air beside the fire reached 22 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak22 µg/m³
Days over the guideline0 days
PM1031 µg/m³
234567
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Condofuri fire last?
Copernicus dates it between 4 August 2019 and 4 August 2019: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 104 hectares (1.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Condofuri (105 ha, 1.8 %).
Did the fire reach a town?
The closest fire to a town centre came within 0.6 km of Condofuri. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 27.7 °C, humidity dropped to 47 % and gusts hit 36 km/h. The fire danger index (FWI) reached 23, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.