Satellites first detected fire on 13 October 2026 in Columbia, United States. It was active for 3 days, with 53 heat detections and an area with fire of about 700 hectares rebuilt from them, spread across 2 counties.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
satellite only
≈ 700ha
Estimated from hotspots: no perimeter has been published yet.
Source
NASA FIRMS · VIIRS
Date
13 Oct 2026 – 15 Oct 2026
+− cross-check
This is an estimate from the VIIRS pixels that saw fire. It will change when the perimeter is published.
Duration by satellite
satellite only
3days
13 Oct 2026 to 15 Oct 2026: first and last day with fire on the page.
Source
NASA FIRMS · VIIRS
Date
13 Oct 2026 – 15 Oct 2026
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
13 Oct 2026
First day with fire seen by the satellites or the perimeter.
Source
NASA FIRMS · VIIRS
Date
13 Oct 2026
+− cross-check
No official record is matched to this page, so the alert time and the cause are not known here.
Hotspots
satellite only
53
VIIRS detections at 375 m. Most intense hotspot: 237 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
13 Oct 2026 – 15 Oct 2026
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
Danger at the start
model
13.0FWI · moderate
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 0.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
21.8°C · 31% RH
High of 21.8 °C and minimum humidity of 31% on 15 October 2026; gusts of 23 km/h on 14 October 2026.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
NIFC has not yet published the perimeter of this fire. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.
Area with fire
≈ 700ha
rebuilt from hotspots, no official perimeter yet
Duration
3days
13 Oct 2026 – 15 Oct 2026
Counties hit
2
counties
Started on
13 Oct
2026
Heat detections
53
in a single hotspot: 237 MW
Danger at start
13
Moderate · FWI index
Where it burned
HOTSPOTS BY DAY
13 Oct15 Oct
The weather it burned in
22°high
23km/h · peak gust
31%lowest humidity
It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 6.1 mm on 22 Oct.
Area with fire inside each county, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until NIFC publishes the official perimeter. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
13 Oct
15.1 °C
33 %
20 km/h
0.0 mm
Moderate 13
14 Oct
19.3 °C
33 %
23 km/h
0.0 mm
Moderate 20
15 Oct
21.8 °C
31 %
18 km/h
0.0 mm
Moderate 19
16 Oct after
23.0 °C
27 %
19 km/h
0.0 mm
High 24
17 Oct after
19.7 °C
37 %
45 km/h
0.0 mm
High 35
18 Oct after
17.8 °C
34 %
24 km/h
0.0 mm
High 26
19 Oct after
14.8 °C
40 %
16 km/h
0.2 mm
High 22
20 Oct after
17.1 °C
42 %
18 km/h
0.0 mm
High 21
21 Oct after
17.4 °C
39 %
19 km/h
0.0 mm
High 21
22 Oct after
11.5 °C
64 %
26 km/h
6.1 mm
Moderate 19
Its twins: fires that started in the same weather
It started with an FWI of 13.0, a minimum humidity of 33% and rain the day before. Fires in the area that started in weather like this since 2016: 17.
FWI at the start13.0
Minimum humidity33 %
Days without rain0
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
Burnt Creek Fire, July 2026
1,687 ha8 daysFWI 16.6Min. humidity 31 %99 km away, in 2026
First rain (1 mm or more) after it ended: none in the following ten days.
It burned an area similar to its twins (700 ha against a median of 915 ha) and lasted 3 days, against 8 days.
In 4 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.6 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
6.1 mmfirst rain
22 Oct7 days after it ended
23km/h · max. gust
It was considered over on 15 Oct, and on 22 Oct 6.1 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 13 of 17, with a median of 3.6 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 6 Oct 2026
After · 22 Oct 2026
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 14 October 2026 the air beside the fire reached 11 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).
PM2.5 peak11µg/m³
Days over the guideline0days
PM1011µg/m³
Optical depth0.20
11121314
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 53Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
According to the heat detections seen by satellite, it burned from 13 October 2026 to 15 October 2026 (3 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet: NIFC has not published it. Heat detections rebuild about 700 hectares with fire (7.0 km²).
Which counties burned?
The fire entered 2 counties: Columbia (448 ha, 0.2 %); Walla Walla (252 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 21.8 °C, humidity dropped to 31 % and gusts hit 23 km/h. The fire danger index (FWI) reached 20, class Moderate.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 8 days and their median area 915 ha; 47 % went past 1,000 ha. In 4 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.6 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
No perimeter yet: the area (≈ 700 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
Dates of the first and last VIIRS detection of the cluster. 53 Suomi-NPP VIIRS detections on those dates.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.