Skip to content
worldfires
US · United States ·

Coal Ridge Fire, August 2023 Blaine

Out · last detection 29 Aug 2023, 21:27 UTC

The fire started on 29 August 2023 in Blaine, United States, and satellites saw it burning for 1 day. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 495 hectares, spread across a single county.

It is the 274th largest in Montana since 2016 (of 302 with a page). Number 266 in United States in 2023, of 305.

Burnt area
495ha
official perimeter (MTBS / NIFC)
Duration
≈ 1day
29 Aug 2023 – 29 Aug 2023
Counties hit
1
counties
Started on
29 Aug
2023
Heat detections
8
in a single hotspot: 35 MW
Danger at start
72
Very extreme · FWI index
Average daily power
150MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 29 Aug29 Aug

How it evolved, day by day

29 Aug 2023 · 150 MW · 8

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
51km/h · peak gust
14%lowest humidity

It had gone 7 days without rain (1 mm or more) when it started. Rain came after the fire: 1.1 mm on 30 Aug.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each county

  1. Blaine where it started
    486 ha reached on 29 Aug
    0.0 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 36 % of the area in United States Strong wind: 27 % of the area in United States Very dry air: 40 % of the area in United States

Day High Min. humidity Peak gust Rain Danger (FWI)
29 Aug 34.4 °C 14 % 51 km/h 0.2 mm Very extreme 72
30 Aug after 25.4 °C 20 % 60 km/h 1.1 mm Extreme 67

Its twins: fires that started in the same weather

It started with an FWI of 71.9, a minimum humidity of 14% and 7 days without rain. Fires in the area that started in weather like this since 2016: 15.

FWI at the start 71.9
Minimum humidity 14 %
Days without rain 7
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Pine Grove Fire, August 2021
6,546 ha 2 days FWI 72.4 Min. humidity 13 % 61 km away, in 2021

First rain (1 mm or more) after it ended: 12.3 mm on 18 Aug.

What happened to them

2 days
median duration
1,210 ha
median area
53 %
went past 1,000 ha
2.3 mm
rain at the end (median; 10 of 15 had it)

It stayed below its twins: 495 ha against a median of 1,210 ha. It lasted 1 day, against 2 days.

In 5 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.3 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.1 mmfirst rain
30 Augthe day after it ended
51km/h · max. gust

It was considered over on 29 Aug, and on 30 Aug 1.1 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 10 of 15, with a median of 2.3 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Aug 2023
After · 5 Sept 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 31 August 2023 the air beside the fire reached 29 µg/m³ of PM2.5. That day averaged 16: 1.1 times the WHO daily guideline (15).

PM2.5 peak29 µg/m³
Days over the guideline1 day
PM1041 µg/m³
Optical depth0.91
27 Aug29 Aug31 Aug
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States

Frequently asked questions

How long did the Coal Ridge Fire last?
The official perimeter only gives the start date (29 August 2023). The end comes from the heat detections inside the perimeter: it burned until 29 August 2023 (1 day from 29 August 2023), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 495 hectares (5.0 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire only entered Blaine (486 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 34.4 °C, humidity dropped to 14 % and gusts hit 51 km/h. The fire danger index (FWI) reached 72, class Very extreme.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 15. Their median duration was 2 days and their median area 1,210 ha; 53 % went past 1,000 ha. In 5 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.3 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: MTBS (US Geological Survey and US Forest Service), official.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.